0
How do you change brake lines on 2000 Chrysler town and country lxi?
Wiki User
∙ 12y ago
Taked off the old ones and put the new ones on. Fill the brake fluid and bleed the brakes... Then take it to a brake shop and have them fix your screwed up installation.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you change brake lines on a 1991 Buick lesabre?
How to change brake lines on a 1991 Buick Lesabre?
Where do you buy the back brake lines at for a 1994 Concorde?
You will need to use the universal brake lines sold at auto stores. You can check at a Chrysler dealer but I think they are discontinued there.
How much do brake lines cost in a 1999 Chrysler Cirrus Lxi?
The price of brakes lines for 1999 Chrysler Cirrus LXI vary depending on the seller. They can range from 30 to 50 dollars as of 2014.
How to replace Brake lines 1996 ford econoline e 150?
how to change brake lines on a 1996 ford econoline e-150
How do you change brake lines on a 95 Chevy lumina?
completely
What does the warning light mean that show a round circle with short lines at the bottom and an exclamation point in the middle on a 2007 Chrysler 300?
Brake System Warning (check your brake fluid, the parking brake, etc...)
Your brakes feel light and there is brake fluid leaking from rear disk brake on a peugeot 106 1994?
change the wheel cylinders or the brake lines
How long does it take to change a brake master cylinder on 306?
Master Brake cylinder replaced and lines bled-how long?
What does the brake line run to under the hood of 1986 Chrysler fifth avenue?
The lines run from the master cylinder to the calipers and wheel cylinders.
Why is the brake pedal feel so low and spongy after a brake change on a 1995 Honda Civic?
You probably have air in the brake hydraulic line. Bleed the air out of the brake lines.
Where is the solenoid on the transmission on a 2000 Chrysler town and country?
It is on the front of the transmission, under where the cooler lines hook on.
Why is the brake petal soft after you change the brake pads?
This is caused by the pressure release in the brake lines when you retract the pistons in the brake calipers to accommodate the new brake pads that are thicker than the ones that are removed.
