i have the cap off but i need 2 mke sure i put it bck on rght their is a black button on the cap when i put the cap on does it go on the left or the right?
The cap will only fit one way. The areas on the cap at the screws are different. One is square, the other is round.
Start with plugs, wires, cap and rotor. Also check fuel pressure.
The cam sensor is the "pick up plate" in the distributor, it is the plate under the rotor inside the distributor cap.
Remove the distributor cap. Do not remove the plug wires. Pull the rotor off or remove the screws that hold it on, it that applies, and revese the process with a new rotor.
Under the distributor cap.
Yes, it does, and a rotor.
Change it. Don't be a dumb.
No, all motors that year have distributorless ignition.
And you still have a skip? Probably a bad injector.
remove the distributor cap and grab the rotor then pull straight up.
It would be recommended.
Need to know the year, make and model to help you.
buy a new distributor cap and rotor. Unscrew the distributor cap (on the drivers side of the engine block), take note how the existing rotor is sitting, remove it, and place the new rotor in the same position. Put on the distributor cap and screw it into place... very simple job. thats how you change the rotor......he asked about the distributor....try again.