Want this question answered?
Remove clutch cable connection and then remove slave cylinder line from master. Then unbolt slave master and remove it. Follow same procedure in reverse order.
You will need to remove the transmission to replace the clutch slave.
How to remove fan clutch on 2003 ford explorer
To remove a clutch slave cylinder from as Astra gearbox, push the piston down against the spring pressure. Then release quickly.
There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.
the slave clutch cylinder is located inside the housing of the clutch/transmission. Unless you really know what you are doing a trained tech probably should replace this part.
Remove the transmission to excess the inturnal slave cylinder
There is no adjustment, The clutch it self is either worn out, Bad clutch slave cylinder. Air are no fluid in the clutch mastercylinder. Fill clutch master cylinder up with fluid, be sure to remove the little rubber cub that is inside of the clutch master cylinder before you fill it up, then bleed the clutch of all air. Then see if the clutch works better.
The slave clutch cylinder on a 1994 Honda Civic is located inside the engine compartment. On the driver-side close the firewall. The clutch fluid should be drained. Remove the mounting bolts and clutch lines to replace the slave clutch cylinder.
to remove a clutch fan on a ford, you need special tools . also fan thread is left hand thread ,so you unscrew it clockwise
Disconnect the hydraulic line nut from the cylinder with a flare nut wrench. Plug the line. Remove the slave cylinder bolts and remove it from the clutch housing. Put the new cylinder on the clutch housing and tighten the mounting bolt. Make sure the brake master cylinder is full of fluid. Have an assistant pump the pedal several times and then hold it to the floor. Then open the bleeder valve on the slave cylinder to let the air out. Do this several times. When the air quits bubblin out you'll want your helper to hold the clutch pedal to the floor while you close the bleeder .
Have to remove the transmission for that.