First take the car to a car wash, steam clean the engine bay, then remove, air conditioning compresssor, water pump, intake manifold, distributor, then valve covers, remove all the bolts you see on the cylinder heads, once you have removed them, , get your engine to TDC (cylinder one on top of the compression stroke,) verifying that the timing mak on the crankshaft pulley is on TDC also (aligned with the mark on the block, usually a metal pin). get the new gaskets, align them with the dowels and pins on the block, install the new ones, then (of course everything is absolutely clean (threads of the bolts included)) then insert and screw the bolts by hand until they seat, then use a torque wrench to tighten the bolts to 1/3rd of the specified torque, ina aspiral pattern frm the center bolt outwards, once you have done this, increase the torque to 2/3rds, and then to 3/3rd (the total) specified value. Then reinstall the intke manifold, distributor (aiming at cylinder 1) valve covers , etc. (please watch some YouTube videos on the subject before starting). BTW it is a hell of a job, you will bruise your hands, and sweat like a pig. Good Luck
Need for info. Motor size ?
It goes in where your dipstick is in the back of motor compartment
As soon as the 2003 Buick Regal change oil light comes on, it is important to do so immediately. Not changing your oil can damage the motor in your car.
If you get the PCM, engine wiring harness, and intake manifold from the Regal also..
fuse for windshield wiper motor for a 1995 buick regal
I need a blower motor and blower motor resistor for a 1999 lasabre will the regal have the same part?
Procedure to change 1988 Buick regal head gasket
the blower motor is under the dash on the passenger side of the car
Yes but you will have to change the Trans and also add Chevy motort mount brackest to the cross member.
yes
Yes
2000 buick regal wiper pulse board /timing wipers