answersLogoWhite

0

  • Ford Escort
  • Chevy Silverado
  • Heater Cores and Blower Fans
  • Pontiac Trans Am

How do you change heater box gasket on firewall 2002 TA?


Top Answer
User Avatar
Wiki User
Answered 2008-06-11 16:41:41

hkjg

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...
Still have questions?

Related Questions

Where is the heater inlet hose on a 2002 Chevy silverado?

The heater inlet hose is on the firewall. On the 2002 Silverado it is close to the bottom of the firewall on the passenger side.


How do you change a heater core on a 2002 Altima 2.5?

how do you change a heater core on a 2002 Nissan altima 2.5


Where is the heater core for a 2002 Chevrolet Blazer?

Mounted on the inside of the cabin, on the firewall, passsenger side.


Where is the heater core located on a 2002 Chrysler town and country?

Look for two coolant lines going into the firewall. That's where your heater core is located.


How do you remove a heater core from a 2002 F-350 Ford truck?

how do I change the heater blower on a f350 2002


Why does the 2002 ford explorer keep blowing heater hoses?

could be head gasket problem. does your heater work? might need heater core , clogged up. do compression test. or bypass heater core and see if that works.


How do you replace head gasket on Buick rendezvous?

How much can cost repair to change head gasket Buick Rendezvous 2002


Where is the coolant temperature sensor on a 2002 Mazda miata?

At the back of the engine on the coolant outlet that goes to the heater hoses on the firewall.


Where do you find the blower motor resistor on a 2002 mercury grand marqui?

ON THE 1993, THAT BLOWER MOTOR RESISTER BLOCK IS LOCATED LOW ON THE BLOWER-MOTOR/HEATER CORE SHROUD (OUT ON THE FIREWALL) JUST TO THE RIGHT OF THE HEATER CORE AND JUST BENEATH A PAIR OF HEATER HOSES THAT GO THRU THE FIREWALL. IT JUST MIGHT ALSO BE LOCATED THERE ON THE 2002.On the '02, it's located inside under the dash, behind a small panel, below the glove box.


Why is water collecting in cabin filter housing of your 2002 grand caravan?

: Your firewall drain tube MAY be clogged on the firewall . You can blow it out with compressed air from the engine side of the firewall. It is hard to get too but not impossible.: The other cause could be similar to what I encountered.I had this water leak in my 2002 Dodge Grand Caravan. It was not a clogged drain on the firewall but a leaking firewall gasket that the drain tube goes through. The gasket was brittle/cracked from heat off the engine. As the vehicle was driven the air entering the engine compartment was forcing the water back towards the worn gasket and it entered the passenger compartment. To replace the gasket was going to be next to impossible. So I purchased a tube of Polyurethane NP caulk from Home Depot. This caulk stays very pliable all year long. I applied it over the gasket area and around the drain tube ...but made sure it did not go in the drain. You may need an extension on the caulk tube to reach the firewall gasket area ... I used a McDonald's straw and taped it to the caulk nozzle to get the caulk on the gasket area. Wear surgical gloves and spread the caulk over the gasket area. 2 years and not a drop of water in the front passenger area of the van.


How do you change the heater core on a 2002 Silverado?

you have to remove the dash and steering column then the heater box I have done many and its at least 1.5 days to do.


Do you need to change the transmission gasket on a 2002 Lincoln Town Car?

Yes, the gasket should be changed ever time the pan comes off for changing the filter or oil.


How do you replace the valve cover gasket on your 2002 Mitsubishi lancer?

how do you replace the valve cover gasket on a 2002 mitubishi lancer


Heater core replacement 2002 Pontiac Montana?

Where is the heater core for a 2002 pontiac montana


How difficult is it to change the head gasket on 2002 Nissan altima?

Extremely difficult as this is a major repair. Best left to a professional.


How much does a head gasket cost 2002 dodge stratus rt?

How much to repair a head gasket for a 2002 dodge stratus


2002 heater blows air but no heat?

Clogged Heater core... common problem with 2002 dodge


How do you change the valve cover gasket on a 2001 Kia Sportage?

i need a detailed diagram on how to replace a valve cover gasket on an 2002 kia sportage. no one makes a repair guide for this vehical


Is there any other way to change heater on 2002 Chevy blazer other than pulling whole dash?

no


Why does heater in 2002 Dodge Grand Caravan heater only work on high?

You have to replace the fan resistor pack. Open the glove compartment and lower the door, look in back on the firewall. Remove the two screws and the connector, pull out the resistor pack - replace it.


Where is the ecu on a 2002 ford windstar?

The 2002 Ford Windstar ECU can be found on the firewall in the engine compartment. The ECU will be on the drivers side of the firewall.


Where is the block heater on a 2002 PT Cruiser?

The 2002 PT Cruiser block heater is located on the front of the engine block. You should be able to follow the block heater cord to the block heater.


Where is the heater blower located on a 2002 Chevy silverado?

The heater blower for a 2002 Chevy Silverado is mounted under the dash. It is on the passenger side, in the heater housing.


Multifunction switch and burning coolant smell 2002 SE how do you change a bad multifunction switch in the 02 and replace the heater core?

The burning coolant smell is your intake gasket. cost me about 600 bucks to fix. I have a bad multifunction switch as well. Haven't gotten around to changing that yet. I have a 2002 Grand Am SE. Good Luck,,, P.S. SELL IT!!!!


Where is the heater core located on a 2002 Mazda 626?

The heater core is located in the center of the dash inside the heater unit. If you look under the dash on the passengers side you will see, from right to left, a blower, the AC box then the heater unit where the core is. Also, in the engine compartment you will find two coolant hoses that enter the firewall near the center, those hoses connect directly to the heater core.