Isuzu Rodeo

How do you change rear main seals in 1996 Isuzu Rodeo?

151617

Top Answer
User Avatar
Wiki User
Answered
2008-10-24 19:32:04
2008-10-24 19:32:04

drop your transmission if it is a manual you have to remove the clutch and pressure plate or automatic the torque converter has to be removed and it should be right there but its hard to get out some times

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


How much oil do I put in a 1996 Isuzu rodeo


how do you find out how to check the transmition in a isuzu rodeo


No it is not, in 1996 Isuzu bumped the horsepower of their 3.2L V6 up to around 195 hp and 193 ft·lbf of torque for the 1996 and 1997 Rodeos continuing into 2004 in which Isuzu operated here in the states under GM dropped the Rodeo line



remove the 2 screws from the red plastic and gently pry the red cover off.


The AC low pressure valve on a 1996 Isuzu Rodeo is located in the back of the engine compartment. The valve is on the larger of the two hoses that run from the evaporator to the compressor.



im sorry i don't kno the gap for the plugs but do you kno the size of the spark plug socket i need and how hard is it really to change these. i have a 95 Isuzu rodeo v6 3.2 please any help would be great hit me up at omenz33@ yahoo.com



in the fuse box ,on the drivers side of the dash.it is a 30 amp circuit breaker.



Same as any other car its located under the car attached to the engine


it is possible to make a snorkel for a 1996 Isuzu rodeo. most snorkels are home made by just extending the air intake through the fender of the car using PVC piping and what is called a "hat", which is the tip containing a filter to block debree and dirt. making a snorkel requirs alot of measuring.


I own a 1997 Isuzu Rodeo and had the same problem. I went to a local Isuzu new-car dealer and was quoted a price in excess of $100 to replace the burned-out dashboard lights. I was told that the cost is high because the top of the dashboard has to be removed in order to obtain access to the lights. I did not have the lights replaced. carlpers


If it is the same as a 1996 it will be top row second from the front in the fuse box by drivers door.


A 1995.5 model has the updated interior similar to a 1996 model, but has the same drive-train as a 1995.


Most online auto part stores will have a downloadable wiring diagram for your 1996 automobile. The diagram can also be downloaded from most dealership websites.


you have to remove the intake manifold then you have to remove the ignition coil and then remove the 8 bolt on each side (have fun removing the bolt) jejejeje then you take the cover off an you finish


The Stereo unit model 8200 in an 1996 Isuzu Rodeo has in the upper right hand corner a small button "Disp". While holing that button down with the stereo OFF, use the "TRACK" selection buttons in the lower left of the center display to select (left button) HOURS, (Right Button) Minutes. NOTE: THere is no designation for PM/Am


You did not say which engine you have but it is most likely driven by the timing belt so any front accesories on the engine that are in the way will need to be removed and a new timing belt will be needed as well.


No it wont work, the 96-97 Isuzu rodeo switches look similar to te 98-02 models but there's a difference.Also used 98 window switches cost more than 96-97 switches. http//:jlkautoparts.com


I think it is the same as my 98 and you put a wrench on the bolt at the center of the tensioner pulley and push away from the belt.


your car may be leaking coolant into the engine, i.e your head gasket may be bad


There are three plugs on the right side of the engine. You have to take the exhaust manifold out to see them. Im not sure if there are any more.


Isuzu Oasis was created in 1996.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.