Typical of worn bearings....crank, cam and rod bearings.
4.5 quarts 10w30
I would like to have a dimgram to show me how to put the hater core out and in on my 94 Pontiac Bonneville
2 right passenge side
It's in your owners manual
There is a side pan which is sometimes accesable if you remove the wheel.
Not enough info, please reask question with year, make, model, and engine size.
The Match Game - 1962 Arlene Francis and Rod Serling 2-94 is rated/received certificates of: USA:TV-PG
I collect old cavs. The bearing cost between $90-$120CDN. It might be smart to change both bearings at once so they wear evenly. I paid $59.98 for one at NAPA earlier today if that helps....
The 1994 Pontiac Bonneville fog light switch can be found on the center console. The fog light switch will be?æbelow the climate control panel.
what are the torque specs for main and rod bearing in 2.2litre s-10
I had this problem on a 94 Bonneville after we had fixed the brakes. After I disconnected the battery and reconnected the light went off and the dinging stopped. Not sure if this was related or just coincidence.
Could be low level or dirty transmission fluid
94/100 = 47/5094/100
well if the 95 Bonneville is like the the 94 Bonneville it should be under the steering wheel on the left hand side near the hood release there should be a fuse box right there i know there is another big fuse box if you open the hood and you look at the engine right by the windshield there is a big fuse box right there. that is only if the 95 and 94 bonnevilles are exactly the same.
it would have to be a 4.3 that trany would bolt up but u would have to change the motor mounts. check with your local rod shop.
If the truck is a 4 wheel drive, you can't repack the front wheel bearings. It has a sealed hub/bearing assembly that is not serviceable.
How do you change a fuel pump on 94 Chevy caprice ls
try wheel bearings If the rear end is posi-trac, take it to a Chevrolet dealership and have 'em change the fluid.
you may need to replace some fuses check the box
Assuming you don't mean GRAND Cherokee (which I am not familiar with), there are no ball joints, wheel bearings or tie rods in the rear of a Cherokee. It could be something as simple as your centercap being loose, your break drum needing adjustment (altho I doubt it), loose lug nuts, or even suspension. Take it to a mechanic.
is it posiable to change your 94 camaro 3.4 eng to a 85 305 eng
I just did this on my 94, For anyone else who wants to do it the belt was a NAPA 25-060725 which is 73 1/4 inches long.
Outer tie rod ended are part of the steering system on a 1998 Honda Civic. They are located in the underside of the front-end of the vehicle.