Dodge Ram

How do you change speedometer cable on 1996 dodge cummins?

123

Top Answer
User Avatar
Wiki User
Answered
2011-02-12 00:26:37
2011-02-12 00:26:37

A 1996 Dodge Ram does not have a speedometer cable. The system is all electric.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


A 1999 Ram does not have a speedometer cable. The speed signal comes from the abs system.

The speedometer is electronic on a 1999 Ram, and does not have a cable.

It does not have a cable. The speed signal comes from the trasnmission output speed sensor.

A 1991 dodge dynasty speedometer bouncing could be a sticking speedometer cable, or a bad drive gear. Check the cable first, and lubricate it to see if the problem stops.

The speedometer does not have a cable on a 1994. It is run by a sesnor on the rear of the trans/t-case.

remove cable from the transmission and remove the cable from the back of the speedometer up under the dash and then the complete cable can be pulled out.

Answerreplace the speedometer cable. the problem will get worse, before it brakes. there is no cure but replacement My 1989 Ford had a gear on the transmission that had to be replaced, cable was okay. Easier than replacing cable if it is like a Ford.

Either a problem in the circuit or a faulty vehicle speed sensor.

The Cummins engine in a Dodge truck does not have glow plugs.The Cummins engine in a Dodge truck does not have glow plugs.

doesn't use a cable, it uses an electric sensor

there is no cable only speed sensor on trans

speedometer cable is gummed up inside the housing.Remove cable from speedometer.Pull out inner cable. Lubricate with good grease and install.

No. The speed signal is electronic.

it's in the dash, the speedometer cable runs the speedometer and it connects to the back of the speedometer and it runs down to the back of the transmission case.

It does not have a cable. The speedometer signal comes from the ABS sensor in the top of the rear axle.It does not have a cable. The speedometer signal comes from the ABS sensor in the top of the rear axle.

there isn't one- equipped with an electric speedometer

The Cummins in a Dodge truck did not get EGR until 2007 with the 6.7L.The Cummins in a Dodge truck did not get EGR until 2007 with the 6.7L.

It doesn't have a speedometer cable. The speed is calculated by the transmission computer using it's output speed sensor.

you just change it you just change it

A 2001 Dodge truck does not have a speedometer cable. The speed signal comes from the rear axle speed sensor. (the sensor on top of the center of the rear axle)

Most common would be speedometer cable has broken Remove speedometer head and move vehicle to see if cable moves- if not probably broken - if it does probably problem with speedometer head

there is no speedo cable so if your speedo isn't working you either have a faulty sending unit or the dash half of it is bad

Cummins owns the engine. Dodge just offers the computer instead of cummins. Cummins is a private company it is not owned by Ford or Dodge.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.