Honda Accord
Honda Accord EX
Honda Accord LX
Honda Accord DX

How do you change the Oxygen sensor of your Accord?

414243

Top Answer
User Avatar
Wiki User
2008-05-27 16:20:30
2008-05-27 16:20:30

If it's a 4-cylinder, it's right on the exhaust manifold close to the radiator. Sometime they'll sieze, but I haven't had one to. Use anti'sieze on the new one. Computer may have to be reset by a dealer or other service outlet. I've disconnected my negative battery terminal to do that before.... Look at your exhaust manifold. If there's a metal bolt-looking thing with a wire coming out the middle of it fairly close to the bottom flange, that's the oxygen sensor. (4-cylinder Accords have one exhaust manifold at the front of the engine; 6-cylinder Accords have another one behind it.) If you don't see this, you've got a carbureted car and, hence, no oxygen sensor. Start by unhooking your battery, then the one wire coming out of the sensor. Use an oxygen sensor socket to unscrew the old one. Put some antiseize on the new sensor, screw it in and torque it to 25 lb-ft. Hook up the oxygen sensor wire, then the battery, and you're done.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Answer There are two o2 sensors, one on the intake manifold and the other on the catalytic converter.where is the oxygen sensor located on 99 Honda accord

User Avatar

The bank 1 sensor 1 oxygen sensor on a 2002 Honda Accord is located on the header. It is right next to the sensor circuit.

User Avatar

The 1993 oxygen sensor is the best sensor for a 1993 Honda Accord EX.

User Avatar

What about it? Where is the rest of the question?

User Avatar

how to replace the water pump on a 1998 Honda Accord

User Avatar

The oxygen sensor on a 2004 Honda Accord is found on the exhaust system. They are placed close to the catalytic converter so the sensors can properly read the exhaust flow.

User Avatar

When the oxygen sensor goes bad, the check engine light goes on.

User Avatar

How do you change oxygen sensor on a 2006 Chevy aveo?"

User Avatar

How do you change oxygen sensor in 1992 Toyota corolla? Is there a model engine 4A-FE without a oxygen sensor?

User Avatar

THE O2 SENDOR JUST SCREWS OFF THE SIDE OFF THE MANIFOLD, THEN YOU JUST UNPLUG IT. JOSE

User Avatar

Please answer the question. "How do you change an oxygen sensor in a 2002 Pontiac Bonneville

User Avatar

Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.

User Avatar

Is it the back one or is it the front one...?

User Avatar

An O2 sensor unscrews like a spark plug and then there are 1-3 wires to rehook up.A special socket may be needed on some models.

User Avatar

Follow the intake manifold. Sometimes, there are oxygen sensors on the exhaust under the car.

User Avatar

A 2003 Honda Accord Oxygen sensor is located on the exhaust pipe. To find it jack the car up and safely position it on jack stands. Crawl under the vehicle and look at the downpipe of the exhaust, the sensor will have two wires protruding from it.

User Avatar

The Oxygen sensor of a 89 honda accord lxi fuel injection 2.0 valve engine is located in front of the engine on the manifold .

User Avatar

Screwed into the exhaust system. Follow the exhaust system from the engine rearward and you will find the oxygen sensor or sensors if it if it has more than one.

User Avatar

A system malfunction in the Primary Heated Oxygen Sensor (Primary HO2S) (Sensor 1) heater circuit.The cause can be a loose wire or a defective Primary Oxygen Sensor

User Avatar

There is no MAF sensor on a 1996 accord.

User Avatar

3, sensor 1 bank 1, sensor 2 bank 1, sensor 2 bank 2


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.