answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2007-05-16 21:35:24

Should be located at the engine end of the upper radiator hose in a housing Drain about 1 gallon of coolant from radiator Remove housing Make note how thermostat is installed Clean both sufaces Replace thermostat and gasket Re-fill coolant slowly to prevent "air lock" Start engine Look for leaks Run engine to normal operating temperature with heater on Re-check coolant level

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
1
๐Ÿ˜‚
0

Related Questions


Either a clogged heater core or a thermostat that is stuck shut.


There is no such thing on a spirit.



iF YOU LOOK AT THE MOTOR YOU WILL SEE A HOSE THAT CONNECTS TO THE RADIATOR. THERE ARE TWO BOILTS REMOVE THEM AND YOU WILL SEE THE THERMOSTAT. JUST TAKE IT OUT AND PUT THE NEW ONE IN. MAKE SURE YOU CHANGE THE GASKET TOO.


Dodge does not use inertia/reset switches.



follow the hose from top of radiator-the hose leads to a neck that is partially buried by the alternator that yoke is the top of the thermostat there are a couple of brackets that have to be removed in order to change it.


not really familiar with a dodge spirit,but a torque converter and a clutch are two completely different things


According to the Gates website , the 2.5 liter 4 cylinder engine in a 1993 Dodge Spirit is NOT an interference engine , so I would say NO


i have a 94 dodge spirit with a 2.5. and the spark plug gap is 0.35 I have a 92 Spirit with the 2.5, all of the 2.5L engines have the cap of 0.350


According to Gates ( they make timing belts etc. ) the 3.0 L - V6 engine in a 1993 Dodge Spirit is NOT an interference engine ( it does use a TIMING BELT )


It is under the housing that the upper radiator hose hooks to on the engine.It is under the housing that the upper radiator hose hooks to on the engine.


The thermostat is located inside of the thermostat housing. It is on top of the motor where the top radiator hose connects. you will have to disconnect the hose to remove the thermostat housing.


the obd connecter is under the hood near the battery


Dodge does not use inertia/reset switches.Dodge does not use inertia/reset switches.



if this is a v6, unless your car has California emissions, there is no EGR valve.



it is in line in your exhaust system, not an easy repair, need to put vehicle on lift, cut off old one, install new..


The fan sending unit is on the side near the thermostat housing.


Should be in a removable housing at the engine end of the upper radiator hose


how to replace steering rack in 1993 dodge intireped



It is in the fuel tank. You have to remove the fuel tank to access.


where is location of thermostat in ford aerostar van, 1993



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.