Fuel Filters
Chrysler Sebring
Air Filters and Intake Manifolds

How do you change the air filter on a 2002 Chrysler Sebring with the 2.7 liter V6?

111213

Top Answer
User Avatar
Wiki User
2015-07-15 21:38:31
2015-07-15 21:38:31

Unscrew the large air hose from the air filter housing at both ends using a screw driver. It is tight, and you may have to disconnect the electrical wires above it for room. Once the large hose is loose, pull it away from the housing, and pull the round tube style air filter straight out. Replace and make sure all connections are reconnected.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

You need to take the intake manifold off and radiator

User Avatar

The best place to find an engine diagram for a Chrysler Sebring would be in the owner's manual. If you do not have your, contact Chrysler or check your library.

User Avatar

I have the 2.7 liter v6 and it runs off the timing chain.

User Avatar

It is built inside the distributor on that engine.

User Avatar

It is under the housing where the upper radiator hose attaches to the engine.

User Avatar

5W30. It can be synthetic, conventional, or a blend.

User Avatar

You can call your local Chrysler dealer and they will run your VIN through their system to check for open recalls.

User Avatar

It is under the plastic covers on the passenger side of the engine.

User Avatar

It is on the front of the crank, under the pulley and timng chain.

User Avatar

The thermostat is under the housing where the lower radiator hose attaches to the engine.

User Avatar

The thermostat is under the housing where the lower radiator hose attaches to the engine.

User Avatar

It is under the housing where the lower radiator hose attaches to the engine.

User Avatar

It is on the radiator side of the engine, behind the motor mount bracket.

User Avatar

The thermostat is under the housing where the lower radiator hose attaches to the engine.

User Avatar

look in your manual's index under capacities and specifications. (or Engine Oil)Oil CapacityThe engine oil capacity with the filter is 4.5 Quarts.

User Avatar

It is located under the housing where the lower radiator hose hooks to the engine.

User Avatar

It is under the housing where the lower radiator hose hooks to the engine.

User Avatar

It is located on the bottom of the engine near the right front wheel. You will see the radiator hose connected to it. It is VERY difficult to change and I do not recommend you do it yourself.

User Avatar

To unplug the oil pressure switch for a 1999 Chrysler Sebring 2.5, simply remove the connector from the back of the switch. With the switch unplugged, the computer will think the engine has low oil pressure.

User Avatar

The 2001 Chrysler 300M 3.5L V6 (Vin code "G') is factory specified for 5-quarts of API approved 10W30 including the filter. The Wix oil filter part number is #51085.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.