On lower part of heater box inside vehicle (passanger side). Remove screws and unhook harness. Pretty simple.
The resistor is to the left of the blower, it is very hard to get to. You'll have to almost stand on your head to change it.
Where is the resistor on 2001 jeep wrangler
Blower motor resistors are generally found nearby the blower motor.
Pull out the lock on the blower motor resistor wire harness connector to unlock the connector latch . Depress the latch on the blower motor resistor wire harness connector and disconnect the connector from the resistor. Remove the two screws that secure the blower motor resistor block to the HVAC housing. Remove the resistor block from the HVAC housing............
how do you test a blowwer motor resaistor pack on 96 jeep cherokee
The heater blower motor resistor should be above the vent, behind and just below the glove box. It should have a three prong connector.
The blower motor resistor is under the glove box. There's a plastic cover over it. You remove the cover and you'll see a connector that is plugged into the resistor. You can see pictures at www.timsjeepblog.com.
Probably the blower motor resistor, check blower motor at the same time
it is under the clove box behind the blower motor you will see it if you look its a black box
blower resistor especially if its chrysler/jeep or blower switch
On a Chrysler/Jeep product that is usually an indication that the blower resistor has failed.
Either your switch is messed up, or more likely the blower motor resistor is bad.
Check the resistor pack on or near the fan , it may have melted and needs to be replaced.
Bad Blower motor fuse Bad blower motor resistor Bad blower motor Bad switch Evaporator plugged- not allowing air flow
Check to see if you are gettin power tothe blower motor - if so motor is bad If not, perhaps resistor or switch is bad Or open wire to motor or resistor
If it works on some speeds and not others, the most likely problem is a defective Blower Motor Resistor Pack. It is located near the blower motor.
Most likely cause is a failed blower resistor.
Replace the blower motor resistor.
Replace the blower motor resistor block. It is located under the dash on the passenger side.
Loose wire on blower motor? Broken bower motor resistor? Bad blower motor? Loose fuse in fuse holder? Bad fan switch?
possibly blower motor some libertys had a recall call your dealer and check also could be the blower motor resistor
Blower motor resistor is the most common problem. it is held in by 2 screws under the glovebox area. Easy to replace.
What fuse number for 2004 Jeep Liberty blower motor?
The blower motor resistor block is located on the underside of the HVAC housing (Heater Box) next to the blower motor. The blower motor is located at the right side of the dashboard. You can access the blower motor resistor block from under the dashboard. A Word of Caution! Stay clear of the blower motor resistor block heat sink - It could be Hot. Incidentally, I have read about people working on their dashboards and setting off the airbag. It is a good thing to disconnect the negative battery cable from the battery and make sure that it can not touch the battery post. Wait at least a couple of minutes for the airbag system to discharge.
Check all the fuses and relays first. If they all appear to be in good working order, then you'll have to get to the blower motor. Could be a short or the motor could be bad.