Headlights Tail and Brake Lights
Chevy Corvette
Pontiac Firebird
Ford Windstar SE

How do you change the brake light bulb on a 1996 firebird?

343536

Top Answer
User Avatar
Wiki User
2011-09-13 00:18:49
2011-09-13 00:18:49

This should be the same a a 1998

open your trunk and pull back the carpet that's in the very rear of the trunk (like behind the lights) the lights should be held on by big plastic wing nuts unscrew them and that gives you access to all your rear light bulbs

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I am also having the same problem with a 96 Firebird. I traced it under the dash, then asked my mechanic. He says it is the turn signal switch.I haven't swaped it out yet, but it's my next attempt. Hope it works.

User Avatar

The 1996 GMC Yukon brake lights work by receiving power from the brake light relay switch. The brake light relay switch is connected to the brake pedal.

User Avatar

Where is the brake light fuse found on a 1996 dodge grandcaravan

User Avatar

from inside the trunk you can dislodge the tailight lenses.... the rest is simple

User Avatar

When you open the hatch back there are two screws, take that off and then pop off the light cover and it is there.

User Avatar

where is the brake light switch for 1996 Oldsmobile cutlas supreme

User Avatar

The Firebird Band was created in 1996.

User Avatar

It is underneath the Brake Pedal.It's mounted to and right above the brake pedal.

User Avatar

Above the brake pedal where the master cylinder is attached to the brake pedal assembly.

User Avatar

I assume you only need to change the bulbs. Go into the trunk and look up. You should see the wires leading to the mounting point for the third brake light, you candisconnect the connectors and then change the bulbs this way.

User Avatar

First check the brake light fuse, if good, then test the brake light switch.

User Avatar

If the red " BRAKE " light in your dash is on that indicates that either your parking brake / emergency brake is on , or the BRAKE FLUID LEVEL in your brake master cylinder ( located in the engine compartment ) IS LOW

User Avatar

'How do you change a fog light in a 1996 Pontiac Bonneville? ... How do you

User Avatar

Check brake light switch - could be defective or not aligned properly

User Avatar

how to change brake lines on a 1996 ford econoline e-150

User Avatar

The red " BRAKE " light in your dash means that either your parking brake is on or the BRAKE FLUID LEVEL in your brake master cylinder in the engine compartment is LOW

User Avatar

It will automatically go off when all the brake lights are in working order. Don't overlook the center brake light. :)

User Avatar

check the wires at brake light switch on brake pedal they are bad about breaking brake light switch

User Avatar

The engine computer through the brake light switch.The engine computer through the brake light switch.

User Avatar

Look under the dash on the 1996 suburban, and locate the brake light switch on the brake pedal arm. Remove the switch nut, and slide the switch out. Unplug the wires from the switch and install the new switch.

User Avatar

I would check the brake light switch first. It's a common problem. The switch is located down on the brake pedal and is easy to change. Use a 12 volt test light to check for power at the switch. You've changed the bulbs or checked for voltage at the brake light sockets first?

User Avatar

It's on the brake pedal just above the viewable area.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.