I have a 92 Bonneville thet needs a crank sensor how do you change it
Crank sensor is on the pulley and the teeth on the pulley sits inside of it for a megnetic response for computer. It is held on by two small bolts.
I changed my own on my 3.8L and my car doesnt want to shift correctly. You are able to adjust and its very picky where the correct position is.
The Camshaft Sensor is located right behind the crank shaft fly wheel and can be very hard to change out without consulting a mechanic first.
'How do you change a fog light in a 1996 Pontiac Bonneville? ... How do you
how do you change a starter in a 1995 Pontica Bonneville?
Please answer the question. "How do you change an oxygen sensor in a 2002 Pontiac Bonneville
how to change steering column on 86 pontiac bonneville
Camshaft position is taken from the distributor, there is no separate sensor.
You need to take of the door panels!
Camshaft position actuator A bank 2 usually means change the camshaft position sensor
how do u change a heater coil on a 978 Pontiac Bonneville
To change the transmission modulator valve in a 97 Pontiac Bonneville you will first need to lift the vehicle off the ground. Then, remove the vacuum hose and the defective valve. You can then replace with new, and replace the hose.
Go here for your answer: http://www.cardomain.com/memberpage/338233/4
you get a 38 rench then get a 4 9 rench
Find it,unbolt it, pull it out, push in the new one, bolt it snug not tight or youll break the new one Or take it to a qualified mechanic
To change the serpentine belt on a 2003 Pontiac Bonneville, loosen the tensioner pulley and remove the old belt. The tensioner pulley is the wheel in the belt system that has a bolt through the middle in a slot that can be adjusted. Put the new belt on and tighten up the pulley.
change the camshaft position sensor, workind on mine.
i have been told my camshaft position sensor needs changing on my Renault scenic 2005 model a have brought one but don't know where it is to change it
You will need to remove the front engine cover, on your 1997 Pontiac Bonneville, in order to change the supercharger belt. Loosen the tensioner pulley to remove the belt.
On my 99 SSEi, it was located on the passenger side just in front of the rear wheel.
In many of the larger GM cars like the Bonneville, the battery is located under the back seat cushion. Need to take out the seat cushion and you will see it mounted in the middle...
The camshaft position sensor on a Mazda Miata is changed by disconnecting the wiring harness and unscrewing the sensor using a wrench. The threads can then be cleaned and a new sensor torqued into place.
the ac condensor on a 1998 Pontiac Bonneville is right in front of your radiator not hard to change at all.
take off serpentine belt unbolt powersteering pump and hoses and drain it. That's it.
Where is the camshaft sensor located in 1997 Chevy venture
The 2000 Pontiac Bonneville takes a 22" wiper blades on both sides front. However, when buying windshield wiper blades be sure to always use the application guide book at the store. The replacement wiper blades will come with step-by-step, illustrated instructions.
Yea, the crankshaft sensor is under the distributor and the camshaft sensor is inside the distributor, you cannot change it so you will have to replace the whole distributor.