To change the center counsel on a 1978 corvette, the seats do not have to come out. 1. Remove the 2 side panels (3 screws each side) 2. Remove 2 screws underneath the front upper portion near the radio ( 1 screw per side ) 3. Remove 2 screws located in the lower central area unit (1 each side ) 4. Remove 2 screws at the rear lower area ( 1 each side ) 5. Remover 2 screws at the rear underside of the unit from the area at the front of the parking brake cover (1 each side) 6. Remove the 4 screws that hold the shifter boot in place 7. Unscrew top shifter button and uuscrew shifter knob 8. lift up rear portion on counsel plate enough to undo power window switch holding screws ( 2 per switch ) 9. Disconnect all electrical / vaccum leads to rest of components eg: lighter, heater switch, ac switch, defogger switch, bulb for shifter indicator etc. 10. move shifter to netural position a manouver the complet unit out. Good Luck, As I been there myself without any help like this fourm. Wish I knew about this site before, it would have made my 1 st. attempt a whole lot easier. Steve ( iceman )
Between the two front seats where the hand brake and shifter are is usually what is called a centre console
under the center console between the drier and passenger seats
Under the center console, between the front seats.
its under the center console between the seats
Yes two back seats, plus a center back console
The airbag sensors are located under the center armrest console. The console is the part between the 2 front seats.
It is under the center console between the front bucket seats. You have to remove the center storage compartment (remove the screws holding it in).
The ecm is located behind the "glove box", in the center console between the seats.
They hold 5 or six people. It depends on if the front has a center console.
yes, it is inside the center console between the driver and passenger seats
The lever should be located in the center console between the seats.
it is directly under the center console between the 2 front seats. Just remove the console and wala there it is.
It is under the console, between the front seats.It is under the console, between the front seats.
We bought a new 2006 Navigator with a center console in the 2nd row of seats, but we wanted seating for 8. At our request, the dealer had the console removed and replaced with a separate seat that sits between the 2 that were originally in the vehicle. This separate center seat folds down, with a little more effort than the two original seats in row 2. Looking at it, you'd never know it was changed out after we bought the vehicle. Don't know how much work it would take to do this, but it definitely can be done. Hope this helps.
There is a latch in the center console between the seats. Pull it, and it should open.
underneath the center console between the front seats
The trunk release is located in the center console between the two front seats. it is a square button.
remove the drawer in the center console near the back seats and then remove the cover that has the two small air vents by pulling it towards the rear seats. Will be visible the stud bolt.
u can remove the center console by first taking out the plastic cover around the ac and stereo. then u open the cup holder and pull it up to remove that whole piece. underneath that u will find two screws that need to be taken out along with two other screws on the side of the console that you will not find unless ur seats are folded forward. once that is done u can remove the center console. u can remove the center console by first taking out the plastic cover around the ac and stereo. then u open the cup holder and pull it up to remove that whole piece. underneath that u will find two screws that need to be taken out along with two other screws on the side of the console that you will not find unless ur seats are folded forward. once that is done u can remove the center console.
i'm guessing you already know you'll need to unclip the locking clips on the sides of the center console, the tricky part is to slide your driver and passanger seats all the way back, then slide the console all the out towards the seats. at this point you should be able to lift the rear portion of the console (the end with the clips)up while leaning the front end down. lift straight up until you clear the seats then you'll probably have an easier time removing the console from the passenger side. note if you have an attachment on the front of the console, then remove the attachment first. i know it seems easy however with some patience you should have little to no problem.good luck
What are the best seats at the broward performing art center/
How many seats in us airway center in phoenix az
the seats are very large
The plug is inside the top front of the center console between the seats under a removable cover.