The first step is to remove the transmission you can pull it all te way out or just slide it back about 2 feet to do this you will need to remove the shifter from the trans. next remove the bolts that hold the preasure plate to the flywheel the clutch disk is between these 2 items. after removing it sand the flywheel slightly then reinstall the new clutch preasure plate and always replace the throw out bearing which is located in the clutch fork . you will need to align the clutach before trying to stab the transmission back to the motor most clutch kits come with a tool to do this .
Not sure what you're asking about. I have a 1998 S10 standard shift that still has a clutch pedal.
No. The Chevrolet S10 series came out in the 1982 model year.
Yes, there is no reason you should not be able to change the oil by yourself in a 1996 Chevrolet S10.
Yes. With proper maintenance and care.
you need to remove the transmission then unbolt the clutch from the flywheel.
7/16 or 11mm
How do you change a Master Cylinder and hydraulic clutch line for a 1998 Chevy S10?
The approximate curb weight of a 1982 Chevrolet S10 v6 standard cab is 3,600 pounds. A modified truck will weight more.
how do you replace hydraulic line on a 1997 s-10
Usually there are 4 nuts holding the clutch and fan on to the water pump shaft. Just pull the nuts, remove the fan clutch and replace it.
You will need to remove the transmission to replace the clutch slave.
change crank sencor
The 2002 Chevrolet S10 was fuel injected.
Set timing on a 2.8 liter v6
It should be, yes.
did a 1984 Chevrolet s10 come with door speakers
4 and 1/2 qts with filter change.
If the fan clutch is locked up it will rob some horse power from the engine as the rpms increase.
where and how to adjust clutch pedal 1993 s10 It is hydraulic operated, there is no adjustment.
It doesn't have a clutch cable. The clutch is hydraulically operated.
Check the low side pressure switch, the pigtail, the compressor clutch itself and then check to see if you still have an air gap between the hub and the clutch when the system is turned off.........
Replacing the clutch slave cylinder requires removing the transmission assembly. I would recommend purchasing a shop repair manual for that vehicle if you intend on DIY.
Napa Auto parts for around $52.00 for the line for the slave and mater assembly around $200.00
The clutch is hydraulic operated, there is no cable.
It doesn't have a clutch cable. It is hydraulic operated.