The coil packs are located behind the engin your will have to Jake up the car and get under it there is a mounting bracket on the back of the motor where the coil packs are mounted to the ignition control modual. there are 2 7/32 screws in each coil pack. or you can remove the whole bracket by 3 13mm bolts but this isent an easy job all of the screws and bolts are hard to get at you will need a couple different sized extentions and a swivle head to take them off and the job will take you about 2 to 3 hours to do.
Click the link.
How do you change a coil pack on a 1997 cavalier
it depends on what motor it has.if its the 4cyl unplug the spark plu wires from the coil pack that is on the back of the motor.if its the 6cyl same thing but the coil pack is on the bottom front of the motor
how to change coil pack on 1998 plymouth neon
If getting no spark, it could be your spark plug wire is bad or your coil pack. say 3 and 6 getting no sparks, that means your coil pack is bad and you need to replace. if you getting no sparks after replacing new coil pack, it could be your ignition module.
Unplug unit and remove bolts?
The 2.8 V6 has a single coil, not a coil pack It is located behind the distributor and on top of the engine. Unplug the wire harness, un bolt and reverse procedure to change.
There is no distributor cap on a Pontiac sunfire, only a coil pack. coil pack is located on the back of the engine.
Only if there is a problem with the coil pack(s).
what is the number coil pack
It's rare a coil pack will go out but it does happen occasionally.
If you have replaced plugs and wire most likely one of your coil pack usually run about $50
I had a similar problem. It was a coil pack. They are about 80 bucks. Fairly easy to fix. If you know how to change a Spark Plug, you should be able to change a coil pack.
To change the spark coil pack on a 1998 Pontiac Sunfire with a 2.4 engine, first disconnect the battery. Then remove the coil pack and spark plug. The spark plug should also be replaced with the new coil pack for best performance. Insert the new spark plug, then the new coil pack being careful not to bump any of the many other electronic parts. Then reconnect the battery.
I cant be arsed tellin ya
remove the coil pack first
it does not have a distributor cap, it has a coil pack, all you can change is the plugs and wires, just fallow the wires from the plugs back to where they end and theres your coil pack, butch
pull of the coil wire and unbolt the 2 10mil bold and its off
Most automobiles will not start with a nonfunctioning coil pack. The coil pack will cause the spark plugs not to fire.
There is no coil wire. There is a coil pack and connected to the coil pack is the ignition control module.
locate coilpack, take out 4 screws ,disconnect leads to new coil pack in order then simply replace new pack and screws.
The purpose of a coil pack is to supply the spark to the spark plugs.
What is the firing order on a 1988 Buick Century.