answersLogoWhite

0

  • Chevy Corsica
  • Crankshaft Sensors
  • Honda Accord EX

How do you change the crank sensor on a 96 Chevy Corsica V-6?

User Avatar

Wiki User

βˆ™ 2011-09-13 00:20:09

Best Answer
Copy

there are 2 crank position sensors. first 1 is the 24x located behind harmonic balancer you will need to remove belt 15mm bolt from balancer and balancer pulley. 2 8mm bolts and 1 10mm bolt are behind the balancer 1 13mm bolt is located on from block which you must disconnect. the other is located on the back of block which is the 7x 1 and this is just a 10mm bolt. It will take some playing around to pull this 1 out but it will come out and goes in very easy. before chaning any1 of these disconnect battery. When putting harmonic back on make sure its lined up w/ key hold and that's it all the way on.

2011-09-13 00:20:09
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Where is the location of the Crank Sensor on a 3.1 Corsica Engine?

The Chevrolet Corsica 3.1 liter engine crank sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crank sensor.


Where is the crank sensor located on a 1988 4 cylinder Chevy Corsica?

It will be on the back side of the engine where the distributor used to be on older engines.


Why did your 92 Chevy Corsica suddenly stall and never start again?

Could be your crank sensor. These are very common to fail on these cars.


Where is the crank sensor on a 2005 Chevy Impala?

where is the crank sensor located on a 2005 chevy impala


Does replacing the crank sensor in a 1991 Chevy Corsica stop it from stalling while driving?

IF... the crank sensor was the problem then it might. However, it is unlikely. I agree, although they are known to crack, It usually results in a no start condition from what I have seen.


Where is the crank shaft sensor for a 1989 Chevy van 4.3 liter?

Chevy did not use a crank sensor on that year.


Where is a crank sensor for 95 Chevy Suburban?

A crank sensor was not USED on a 1995 model.


Where is the crank sensor located on your 1989 2.8liter Chevy Corsica?

behind the engine,in front of the transmission, about half way up the side of the block, its very hard to see its near the knock sensor.


How do you change crankshaft position sensor?

where is the crank shaft pistion sensor located on a 2002 Chevy Malibu, and how hard is it to replace


Camaro 1999 z28 crank position sensor?

how do you change a crankshaft position sensor on a 1999 chevy camaro z28?


Where is the Location of the crank position sensor for 1994 Corsica 3.1?

its locted by the crank pulley the ower pully on the car


Crankshaft sensor for a Chevy Lumina?

Where is the crank sensor on a 95 chevy lumina car ?


What is the Location of crank shaft sensor 1992 Chevy truck?

That year model does not have a crank sensor.


Crank sensor location 84 Chevy 2.0?

They did not use a crank sensor in 1984, There was no need for 1


How do you remove a crank sensor on a 1997 Chevy blazer?

First find the crank sensor and then kick the crap out of it :D


Where exactly is the 2000 Chevy Impala crank shaft sensor?

install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft


Where is the Chevy Aveo crankshaft position sensor?

Locate crank shaft sensor 2005 Chevy aveo


Does a crank sensor have anything with starting on a 96 Chevy vortec?

if the crank sensor is bad it does not tell the computer that the crank is turning it will not fire up the engine.


Does a 1995 Chevy Camaro Z28 have a crank sensor?

No it does not


Does a 95 Chevy Blazer have a crankshaft sensor?

That year did not use a crank sensor.


Where is the crank sensor in a 1991 Chevy 5.7l v8?

1991 probably doesn't have a crank sensor, it probably has a reference in the distributor.


Where is the crank shaft sensor located on a 2010 Chevy Malibu?

2010 chevy malibu intake position sensor


Where is the crank sensor on a 2003 Chevy Silverado?

Behind the starter.


Does 94 Chevy s10 have crank sensor?

Was not used in that year.


Does a 99 Chevy have a cam sensor and a crank sensor or just one?

It has both, The crank sensor is on the timing cover passenger side behind the balancer. The cam sensor is the distributor, Inside of it.