answersLogoWhite

0


Best Answer
Copy

it is on the driver side of the bellhousing-near the top-it is hard to get to if you are under the trans you can look up and see it .you may have to drop the rear of the trans a little bit by unbolting the crossmember..good luck

User Avatar

Wiki User

โˆ™ 2015-07-15 20:01:45
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you change the crankshaft positioning sensor on a 1996 Grand Cherokee with a 4.0L?
Write your answer...
Submit

Related Questions

Where is the crankshaft positioning sensor?

98 Hyundai crankshaft positioning sensor location


Where is the crankshaft positioning sensor on 2003 Kia Sorento?

Can someone anyone please tell me where is the Crankshaft Positioning Sensor on a kia sorento 2005 and I also need a diagram


Why wont my car start when it turns over?

there are many different things that it could be check the camshaft positioning sensor, the throttle positioning sensor, and the crankshaft positioning sensor.


How do i Troubleshoot a crankshaft positioning sensor on a 1995 Jeep Cherokee?

Check the computer for error code 11. http://www.jedi.com/obiwan/jeep/dtc.html


How do you replace the crankshaft positioning sensor on a 1989 ford sho Taurus?

To replace the crankshaft positioning sensor on a 1989 Ford Sho Taurus, go near the water pump at the front of the car and remove components that block access to the sensor. Remove the two bolts holding the sensor in place remove the wire that sends data. Finally, replace the crankshaft positioning sensor.


Will a bad crankshaft positioning sensor prevent spark to spark plugs?

Yes it can. The crankshaft position sensor is one of the major sensors for spark timing.


Where is the crankshaft positioning sensor on a 99 Elantra?

The crankshaft position sensor (CKP)is located on the front side of the engine block,near the flywheel/driveplate


Crankshaft positioning sensor location?

This sensor provides a signal to an engine management computer or an ignition control module or igniter indicating the position of the crankshaft.


Crankshaft positioning sensor location Chevy S10 2.2l?

You will find the crankshaft position sensor on the passengers side of the engine block, close to the starter.


What is BMW diagnostic code po340 mean?

Crankshaft positioning sensor fault.


Where is the crankshaft sensor on a 2001 Jeep Grand Cherokee 4.0L?

The crankshaft sensor on a 4.0L Jeep Grand Cherokee is mounted on the top driver side of the transmission bell housing.


Where is the crankshaft positioning sensor located on a 2000 Mercedes e320?

The 2000 Mercedes-Benz E3 20 crankshaft position in sensor is located on the back of the crankshaft. You will need to remove the rear engine cover in order to see the sensor.


Crankshaft positioning sensor 1994 Honda civic D16Z6 motor?

its located in the distributor.


Where is the crankshaft position sensor for a 2002 Jeep Grand Cherokee 4.7 liter?

The crankshaft position sensor in a 2002 Jeep Grand Cherokee 4.7 liter is located left of the starter. In order to remove the crankshaft position sensor the CKP mounting bolt will have to be removed first.


How do you bypass a crank sensor in a Jeep Cherokee?

You can not. The crankshaft position sensor is required to run the engine.


Where is the camshaft positioning sensor on a 1995 jeep cherokee located?

Inside the distributor.


How do you change a crankshaft sensor on a 1996 Plymouth Voyager?

The crankshaft positioning sensor is located between the engine and the transmission about one third way down looking from inside top of engine. It is not easy to find. You are looking for a connector wire with the sensor, it is bolted onto the transmission with a 10MM bolt.


Where is the crankshaft sensor on a grand Cherokee Laredo with 4 L engine?

The crankshaft position sensor is on the top driver side of the transmission bell housing.


Where is the sensor for a 2000 Jeep Cherokee?

It depends on which 'sensor' you are replacing. The crankshaft positioning sensor is on the lower left side of the engine, behind the oil filter. The CPS attaches to the bell housing. Search youtube for videos on replacing this particular sensor. Other videos may assist with other sensors.


Where is the throttle positioning sensor on a 1999 Jeep Cherokee?

The throttle position sensor is mounted on the side of the throttle body


Where is the crankshaft position sensor on a 1998 Jeep Grand Cherokee 4x4 with 4.0?

The crankshaft position sensor is on the top driver side of the transmission bell housing.


Where is the crankshaft postioning sensor on a 97 Nissan pickup xe 2400?

The 1997 Nissan pickup truck crankshaft position eight sensor can be found on the back of the engine. The positioning sensor will be halfway down the engine block.


Can a crankshaft position sensor stop a 86 Jeep Cherokee from starting?

Yes.


Does a 2004 jeep Cherokee have a camshaft and a crankshaft sensor?

YesYes


How do you change crankshaft sensor in a 2001 Saturn sl?

were is crankshaft sensor located in 2001 Saturn l300