Pontiac Sunfire
Ford Explorer Eddie Bauer
VW Sharan

How do you change the fan resistor for 99 Pontiac sunfire gt?

181920

Top Answer
User Avatar
Wiki User
2011-09-13 00:20:59
2011-09-13 00:20:59

what i did for a ground on my girlfriends 96 sunfire was in the trunk there are hooks that hold the cargo net and the carpet down. unscrew it and just place the ground cable in between the bolt and where it will be screwed into that works fine.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

in side the fan blower under glove department on passenger

User Avatar

The 2005 Pontiac fan motor resistor is located on the back of the fan motor. The fan motor resistor is attached to the fan motor with two retaining screws.

User Avatar

Try looking under the passenger side foot area. The blower motor will be there, and the blower motor resistor should be there also, will have a wiring harness and I believe 2 bolts holding it.

User Avatar

easiest to pull blower motor then you can get at resistor, best to have a flexible extension (not a swivel) and you can access the bolts easier

User Avatar

If you mean the HVAC fan, the resistor should be located within the fuse block.

User Avatar

check to see if the thermostat is hung open or your temperature sensor for your fan is out and causing your fan on your radiator to run continuously when key is on.

User Avatar

I had a similar problem in a Pontiac Sunfire. The guy at the dealership said it's a common problem with the switches they use for fan control in Chevy/Pontiac vehicles. It's about a $10 part.

User Avatar

Buy a new one and you will see what it looks like and it is mounted on the evaporator case.

User Avatar

Check for a bad blower resistor at blower motor

User Avatar

If the AC is on constantly, the fan will be on constantly. If that's not it, it mught be the fan relay or the temperature sensor.

User Avatar

The resistor drops the power to the fan and the fan goes slower.

User Avatar

Should be accessible at passenger side firewall Disconnect wiring harness Disconnect drain Remove 3-4 bolts Twist to remove

User Avatar

take the blower motor out you will see two plugs one for the motor and the other for the resistor two screws hold it in place looks like a motherboard price for new one is about 30.00

User Avatar

Why are you replacing the switch? If the fan works only on high speed, replace the fan resistor. There was a TSB for this.

User Avatar

There is a resistor pack operated by the fan switch. It has failed. You need to replace it.

User Avatar

The 1999 Nissan Quest radiator fan resistor is attached to the back of the fan motor. The resistor should be labeled as such.

User Avatar

How do you replace a fan blower resistor on a vauxal Corsa?

User Avatar

Most likely it is a fan motor that is pulling too much amperage. I'd start with the fan motor and/or the fan motor resistor.

User Avatar

Check out the following website for pics and instructions: http://www.oqcgp.com/forum/kb.php?mode=article&k=70 Hope this helps. "G"

User Avatar

i have an 03 grand prix and yes it was the blower motor resistor also check there is a fuse for fan low and fan high or something like that


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.