Nissan Altima
Ford Escape XLT
Chevy Camaro Z28
1995-2005 Chevy Cavaliers

How do you change the fog bulb on a 1998 Altima?

303132

Top Answer
User Avatar
Wiki User
2007-12-04 17:28:40
2007-12-04 17:28:40

Hi!! if you are talking about the original Nissan fog lamps,, its some kind on triky job,, but not too hard,, first you need to take out the entire lamp,, for this job you need to unscrew the lamp,, there is two screw an one side of both lapms,, you can reach it from the front of your vehicle,, after you unescrew the lamp, disconect the cables,, then you see better how to do the job,, take out the black protection cap,, then you will see inside, there is an assembly arm, unlock it to extraxt the bulb,, then repeat these steps for the other lamp.. its not a hard job,, but you cant do it in 5 minutes,, takes a little longer,, good look! Jesus S.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How do you change a fog light bulb on a 2004 VW Passat?

User Avatar

To change a fog light bulb on a 1998 Neon, loosen the screws holding on the lens covers. Remove the old bulb and replace with new. Then replace the lens cover screws.

User Avatar

how do you replace a bulb in a fog light on a 2000 maxima?

User Avatar

How do you change the fog light on a 2005 Chevy Equinox?

User Avatar

The lowbeams are H11, highbeams are H9, and the factory fog lights are also H11.

User Avatar

reach behind it turn the back of the bulb socket counter clockwise

User Avatar

According to the 1998 Ford Expedition Owner Guide : The fog lamps use ( bulb # 899 )

User Avatar

you have to remove the bumper

User Avatar

To change a light bulb for a fog light on a 1987 Trans AM, the engine must be switched off. Once the engine has been switched off the light bulb can then be changed.?รฆ

User Avatar

Remove fog light bolts and lower the housing.Then just rotate the bulb and remove, replace and reinstall.

User Avatar

The dealer said that you have to remove the front bumper in order to even get at the bulb to change it!

User Avatar

eazy way to change fog lamp on ve commodore 2007

User Avatar

if it is the new shape you have to remove the wheel arch liner then you can get to the rear of the fog light to change the bulb, hope this helps

User Avatar

"i believe you have to change the entire fog light assembly." Wrong Answer. Correct Answer: Remove the wheel well splash guard to access the fog lamp assembly. Twist the harness and remove the old bulb. Replace bulb. Twist harness back into fog lamp assembly. Replace the wheel well splash guard. Done.

User Avatar

2 STEP PROCESS: 1. TAKE FOG LIGHT BULB OUT. 2. REPEAT STEP ONE(1) IN REVERSE

User Avatar

The fog lights on a Chevy Malibu can be reached from under the car. Pull off the old lights and toss out the bulb. Replace with a new bulb and reinsert the light in the fog housing.

User Avatar

You have to remove the front bumper, remove the headlight assembly. then take the fog light bulb out.

User Avatar

crawl under car then twist off the back of the fog lamp. undo the wire leading up to the bulb and then unhook the metal clip that holds the bulb in place. Put new bulb in and then put assembly back together.

User Avatar

Assuming this is for one of the 2 rear fog lamps, then remove the three bolts from the rear lamp housing. The fog lamp is the bottom bulb in the set. Give the bulb holder a quarter turn anti-clockwise and remove the bulb and holder from the lamp housing. The bulb is held in place by a plastic clip either side. Spread the clip sideways slightly and the bulb will pull out. Put new bulb in and replace.

User Avatar

Replace the bulb, had to change one myselfe.

User Avatar

there are two bolts on the top of the fog lights, pul the entire fog light out then you will see a hatch at the back of the light. open it and remove the bult

User Avatar

Remove the headlight directly above the fog light,you can reach down easily to access the lamp


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.