0
Car: Peugeot 306 break (European model)
The rear fog light is held in by a plastic clip at the median side (towards the middle). Insert a thin flat bladed scraper of screwdriver at the inner side (towards the middle, see graphic below) and the light pops out.
Left side holds rear fog light, right side holds only reflector (no light).
Keywords: Peugeot | Peugot | 306 | break | estate | rear | back | fog | light | lamp
LEFT [ ]<-- -->[ ] RIGHT
(insert screwdriver at arrows)
Wiki User
∙ 14y ago
Wiki User
∙ 12y agovery easy
look inside your boot and remove the plastic cover behind your tail light , it just clips on and off. Put your hand into the opening and locate two plastic wingnuts , one at the top and one at the bottom, remove these and then the whole tail light unit can be removed from the car from the outside.Replace bulb and return unit in reverse sequence easy once you know how it only takes about 5 mins, what a pity the front bulbs are not as easy.
regards
Colin
Wiki User
∙ 15y agoapproach light from the inside flap, open access flap by pulling it, turn the cover and pull it out, push securing clips and remove the bulb. approach light from the inside flap, open access flap by pulling it, turn the cover and pull it out, push securing clips and remove the bulb.
Wiki User
∙ 15y agoif its the front lift bonnet at the rear of headlight there is a black round cover, remove and locate sidelight bulb, remove and refit in reverse, if rear remove cover ar rear of vehicle in the boot locate plasic cover directly behind light locate plastic wingnut and remove , disconnect wiring by pressing securing clip and remove light unit unclip bulb holder and fit bulbs as required, refit is reverse of this
Wiki User
∙ 12y agoI assume the 107 will work the same as the 207 and 206: There is a wing nut in the boot near the light fitting (in some models this is hidden by a plastic plug). Unscrew it. The whole light fitting can then pop off externally. Unplug the electrical connection. Unsnap the plastic snaps to separate the front of the fixture from the back to get access to the light bulbs.
Wiki User
∙ 14y agoIf you are referring to the rear lights on the main body, these are retained by a top and bottom knurled nut accessible from the pull off panel lids at the rear of the side panels, once unscrewed (watch you don't drop the bottom one) the light is pulled outwards from the rear of the vehicle.
As regards to the ones behind the rear door the back panel, these have to be carefully eased up from the bottom to access the inside of the rear door, press in panel studs being permanently attached to the felt covered hardboard back, and the plastic retainer cups in the metal frame of the door.
Add your answer:
Earn +20 pts
How to remove rear light on Peugeot van?
fitting rear bulb peugeot expert van
How do you change the rear lights on a Peugeot 607?
You need the near pair of the rear lights and a screwdriver to unscrew the screws if you want to change the rear lights on a Peugeot 607.
Where is the fog light switch in a peugeot partner?
On the turnsignal/light switch lever, on the same turn ring switch as rear fog light. If not you got change it to one with it.
Where is the fog lights switch on Peugeot 307?
Peugeot 307 fog light switch, is a ring located on same lever used to activate direction light. According Peugeot 307 equipment, it could have rear and front or just rear fog light
How do you change Brake pad change on a Peugeot expert?
how to remove and fit rear brake shoes on a peugeot 206 1.1
How do you remove rear light cover on Peugeot 607?
You can remove the rear light cover on your Peugeot 607 by squeezing the tabs located in the middle of the light cover together. Once the tabs are depressed the light cover should come off.
How do you change a peugeot 106 rear axle?
Go to a garage
Your brakes feel light and there is brake fluid leaking from rear disk brake on a peugeot 106 1994?
change the wheel cylinders or the brake lines
How do you change rear wheel bearing on peugeot 307 2004?
Check
How do you change front indicator bulb proton persona 1997?
Inside the bonnet at the rear of the indicator light fitting is a steel ring. This is a clip-in spring fitting. Once unclipped the indicator unit slides out. The bulb is attached by a simple push on fitting.
How do you change the rear brake lights on a peugeot 307 hatchback?
You can access the rear brake light from the cargo compartment. Remove the brake light connector. Take hold of the light bulb, push in and turn at the same time, to remove. Reverse the process to install the new brake light bulb.
How do you replace the tail light bulbs on the Mk II?
open rear trunck lid. you will see fittings for the lights in rear light assembly. locate the fitting for the light that requires replacement. turn fitting counterclockwise and pull out. pull light bulb out of electrical socket.
