Well first you have to ask yourself if it is disk or drum in the front. Now most vehicles in that year are disk in front and drum in the rear. If it is a disk brake setup it should be fairly easy. First you must remove wheels, then you must see how the caliper is bolted on. Then un bolt it. Make sure you see how the brake pads are set into the caliper before removing. Remove. Replace. Installation is opposite Removal.
Need to know if this is a 2 wheel or 4 wheel drive S10.
you must take front grill off.
fordparts.com shows disc brakes on the front of a 1988 Ford Ranger
Remove the tire and wheel from your 1988 Ford Ranger pickup truck. Remove the brake pads. When the brake drum is not loose you can tap on it with a hammer or mallet. Once the brake drum is loose it will slide off.
54mm
Yes. It's located in front of the catalytic convertor.
If you are talking about a canter you need to take the half shaft out
Front or rear?
When ws the last time you change it? It might have some rust inside from the hyd. liquid. Take it to the mechanic
change the pickup coil in distr
Driver's side closest to the front
Remove Distributor,remove drive gear,remove shaft,remove pickup coil.