answersLogoWhite
Brake Pads and Rotors
Chevy Silverado
Isuzu Rodeo
Toyota Tundra

How do you change the front rotors on a 2000 Isuzu Rodeo 4wd?

646566

Top Answer
User Avatar
Wiki User
2015-07-15 18:22:39
2015-07-15 18:22:39

First remove the outer wheel hub by taking off the 6 hex head bolts, then remove the retaing ring around the axle stub. Next remove the 6 bolts holding the hub to the rotor. wipe away the grease in the center of the hub you will find 3 small set screws, remove these. After you have done that remove the plate the screws held on by prying it with a flat head towards you. using the flat head spin the nut off behind it by pushing it into one of the two slots cut into it. You will then have to remove the caliper and the caliper carrier to get the rotor off.

Related Questions

User Avatar

wear gloves, bearings all come out. then you have to remove the sensor off the back of it. along with 6 17mm bolts. How do you change the rotors in the front on a 1998 Isuzu Trooper

User Avatar

How do I remove the front shock bottle pin of my Isuzu rodeo 2000

User Avatar

your bst bet is to get to them through the front wheel wells.

User Avatar

On a 1997 Isuzu Rodeo, the oil filter is located on the bottom front of the motor beneath the fan.

User Avatar

hoew do you remove a c v axle from a 97 isuzu rodeo front right

User Avatar

Need to know which bearing and which Rodeo. There is a Isuzu Rodeo and a Holden Rodeo. Each has several bearings.

User Avatar

Change front brake rotors on a 1998 Hyundai Accent?

User Avatar

The front transmission line leaks, how do I replace it?

User Avatar

Remove caliper and pull rotor off the hub. Push new one on, replace caliper and pads.

User Avatar

front of engine behind harmonic balancer

User Avatar

The speaker covers are held in with a screw, remove it and tilt it out away from where the screw was. then remove the screws holding the speaker in and remove the speaker.

User Avatar

How do you change the front rotors on a 2004 Chevy tracker

User Avatar

Remove the wheel, the calipers and the rotors, reverse procedure with new rotors.

User Avatar

More than likely you will need a new transmission, a new front axel with differential and a half shaft.

User Avatar

Its under the front end of the vehicle, under a large black guard

User Avatar

How to Install Front Brake Pads Check Related links below.

User Avatar

The front speakers are 4" and the rear speakers are 5 1/4 "

User Avatar

14 mm wrench or socket--top bolt does not loosen--take out bottom bolt and snap out pads -- front and back of each wheel

User Avatar

The PCV is screwed into the front of the intake manifold, top right and has a hose coming out of it.

User Avatar

Tap on the rotors with a hammer, after removing the tire and wheel and the brake assembly. The rotors will come loose. Slide the rotors off and reverse the process.

User Avatar

The front rotors need to be pressed on, if you know someone with an industrial press you can do it yourself.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.