This is usually done by a repair shop using an alignment rack costing several thousand dollars...this is not something that you can eyeball?? there are two sets of bolts located on the tie rod that has to be removed...then the tierod has to be turned to be aligned to the spec sheet. Take it to a shop and get a four wheel alignment.Maybe about $60.00, or several hundred for new tires.
The fact that you ask the question tells me that you have no business attempting this. Replacing struts can be dangerous if you don't know what you are doing and don't have the proper tools. Suck it up and pay an expert to do this.
My 2000 Jeep Cherokee makes a clunking noise from the front. I just had 2 bad ball joints replaced but it still makes the noise. I asked about boots but was told I do not have boots on mine. I asked about the swaybar link. They asked me if my Jeep makes the noise driving over bumps and it doesn't. I am at a lose. They are going to look at it and see if they can figure it out. Can you help me with this.
The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
yes it will because i have 26 inch rims on my 2005 ford explorer the only thing is it will rub a lil on the front so youll have to grind some of the fender wall down and make sure you also cant make big sharp turns
no
Either no spark or no gas
The 2000 Ford Explorer front hub nut has a torque specification of 140 pounds of pressure. The hub should not be over tighten. Over tightening can ruin the seal.
The 2003 Subaru thermostat is located inside of the thermostat housing, on the front of the engine. The thermostat will be near the bottom of the engine.
they do not have timing belts , they have chains , one in back of engine and one in front
The 2003 Ford Explorer has 43.9 in. of front leg room.
The 2003 Ford Explorer has 55 in. of front hip room.
The 2003 Ford Explorer has 59.1 in. of front shoulder room.
The 2003 Ford Explorer has 39.9 in. of front head room.
The front track of the 2003 Ford Explorer is 5 ft. 0.9 in. (60.9 in.).
There is a complete walk through with pictures on how to change the front bearings on a 2003 Ford Explorer on my site: http://conceptxchange.wordpress.com/2011/06/23/changing-the-front-hub-assembly-on-a-2003-ford-explorer/
replacing 2003 fore explorer sport front wheel bearings
A 2003 Ford Explorer Sport ( the two door version of the Ford Explorer ) has shock absorbers front and rear
the answer to this is questions is get on the floor
6x8 for front and rear
its may be due to a front in alignment. I have a 2003 durango and that was my problem