Relieve the fuel pressure at the pump switch located in the passenger compartment under the carpet of the transmission hump on the passenger side. Remove the fuel tank. Turn the lock ring counterclockwise until it's loose and remove the lock ring. Pull the fuel pump/sending unit from the tank being careful not to bend the arm for the sending unit float. Discard the old lock ring seal. Installation is reverse of removal with the following additions: (a)Apply a coat of heavy grease to the new lock ring seal to hold it in place during assembly. Install the seal in the lock ring groove. (b)Install the fuel sender/pump unit into the fuel tank so that the tabs of the unit are positioned into the slots in the fuel tank. Make sure to keep the seal in place during installation until the lock ring has been tightened properly. (c)Hold the fuel sender/pump unit in place, install and tighten the locking ring clockwise until the stop is against the retainer ring tab. - Mazda Pickups Repair Manual
put your hand in the gas cap and clean it with a sponge
There is a special tool you need. Available at most auto supply stores.
The fuel pump is in the fuel tank and the fuel tank will have to be removed to access it. If you do not have the skill or equipment to do this properly, I suggest taking it to a shop.
Fuel pressure for 1998 and later models (key on, engine off or engine running): All except 3.0L Flex Fuel . . . . 56 to 72 psi - Haynes Repair Manual # 36071, 1993-2005 Ford Ranger Pick-ups. Manual also includes 1994-2005 Mazda Pickups B-Series.
The fuel filter is located with the frame rail on the driver's side and requires quick disconnect tools to change it. You are probably better off having it done the next time you have it serviced since even the cheap disconnect slip rings will cost you ten dollars and you will probably never use them again.
left frame rail between tank and engine
The fuel filter is located is mounted within the left frame rail. You will need a special tool available at most auto parts stores to remove the push-connect fittings from the filter.
where is a fuel filter on a Mazda Proceed located and how to you replace it?
in the fuel tank
Yes. I believe you are suppose to change it 12 or 15k miles
The Mazda 323 fuel filter is located in the fuel tank. The fuel tank will need to be drained in order to change the fuel filter.
location of fuel pump relay
in the petrol tank
You can't. It is part of the fuel pump.
how to change a fuel pump in a 1998 Chevy Corvette
where is the fuel filter on a 2003 mazda 6 2.3l.
what has to be removed to get to fuel filter
how u change fuel filter on 1998 BMW 740 il
The Fuel cut off switch is under the dash on the passenger side of the truck. It's a small little black gadget that has a red button on top and one plug going to it.
its up by the throttle body after the fuel line off of the fuel filter
Mazda truck fuel pumpInside the fuel tank, unfortunately. I reccommend using an O.E.M. fuel pump from Ford/Mazda even though they are much more expensive. You don't want to do this job twice! Over
to hard.. get a mechanic to do it.......
you gotta drop the fuel tank. it's inside
It is located in the fuel tank.