First: You have to calculate 7 h for this! Then it's the best, if you buy a Chilton Manual No 20384 (Chrysler front wheel drive cars 6-cyl. 1988-1995 repair manual) to see more. You have to remove the wheels and brakes to access the tranaxles and to remove them and you must remove all the tubes to have access to all screws.
The first step on how to change the motor on a 1992 Chrysler LeBaron V6 3.0l is to position the vehicle to where you can get the hoist in and out.
If you have a 4-cylinder, about 20 minutes. 90 minutes if you have the V6.
Yes, it fits (if both are 4 bangers or if both are V6)
Spend $15 bucks or so for a haynes manual from the local autoparts shop.. your gonna need it.. :)
2.5l four cylinder or a 3.0l v6
its 5 quarts for about any engine. 4.5 quarts for the 3 liter v6
If it is a 3.0 liter V6 EFI. Then it will be .044
It is an A604
You will find it (the PVC valve) in the same place as you would on a 1995 Lebaron 3.0. I own a 1990 Chrysler lebaron 3.0 v6 and found the PVC valve in the same spot. Look up where to find the PVC valve on a 1995 lebaron 3.0 on this site. Best of luck.
V6, .044 inch. Four cylinder, .035 inch
V6 is 40 psi, four cylinder is 15 psi.
You dont need a diagram.. just trace the route with the eye.. Besides.. if your going to change the alternator belt.. you might as well change all 3 if its on the V6.. Oh.. and is a PIA job..
I have a set (3) of facturary manuals for the 92. Do you think they use the same wirring diag?
If it is the same as my 1991 Lebaron it is located just above the oil filter. You will have to take the oil filter off and the starter off to get to it.
you have to pull off the distributer the modual is under the roter held with to little screws
you pull the two latches above the sun visors and then there is a button on the center console
How to change the oil filter on a 2009 Camry V6?
Yes it is
Four cylinder, rear of the engine under the exhaust manifold. V6, front of the engine behind the motor mount.