answersLogoWhite

0

  • Mazda Miata
  • Ford Windstar SE
  • Ford Expedition Eddie Bauer
  • Ford Expedition XLT

How do you change the heater hoses in a 1997 Miata?

User Avatar

Wiki User

βˆ™ 2007-02-27 21:16:47

Best Answer
Copy

1. Undo the Hose clamps by the engine and the firewall . 2. remonve hose . 3.Put on new hose . 4.tighten .

2007-02-27 21:16:47
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Add your answer:

Earn +5 pts
Q: How do you change the heater hoses in a 1997 Miata?
Write your answer...
Submit

Related Questions

How to change heater core 1997 ford escort wagon?

The dash must be completely removed in order to gain access to the heater box. Then the heater hoses are disconnected and the heater box is removed and opened up. That gains access to the heater core for relacement.


How do you replace the heater core on e150 1997?

How do i change the heater core on a 1997 ford e150


How do you bypass a heater core on 1997 Isuzu Rodeo?

Couple inlet and outlet hoses together


How do you remove the heater core in a 97 sentra?

Remove the water supply hoses from your 1997 Nissan heater core. Remove the heater core retaining bolts. The heater core will come out.


How do you replace a heater valve on a 1997 Chevy Tahoe?

it is located on the passenger side wheel well...it has 4 hoses attached 2 going into the heater core and 2 going into the engine...simply disconnect the hoses and replace with new heater valve


How do you bypass the heater core on a 1997 jeep wrangler?

just pull the hoses off the heater core and put them together easy all done under the hood. Mike join the 2 hoses together


Replacing heater core on 1997 Pontiac Bonneville?

Begin by training the water from your 1997 Pontiac Bonneville cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.


Temp gauge not working trying to locate sensor location in 1997 Mazda b2300?

Try heater hoses.


Where is the heater core on a 1997 Mercury Mountaineer?

Behind / below the glove compartment area inside a plastic case . You can see where the heater hoses connect to the heater core at the firewall in the engine compartment


How do you install a heater core on a 1997 Ford Escort?

The dash must be completely removed in order to gain access to the heater box. Then the heater hoses are disconnected and the heater box is removed and opened up. That gains access to the heater core for relacement.


Where is the heater core located on your 1997 mercury mountaineer?

Behind the glove compartment area inside a plastic case . From the engine compartment you can see where the two heater hoses connect to the heater core at the firewall


How do you change the heater core of a 1997 corolla and what are the symptoms of a bad heater core?

coolant on the floor


How do you you temperary bypass heater core for a 1997 GMC Savana Van?

Connect hoses under hood together with a coupler for garden hoses from a hardware store and a couple 5/8 (or thereabouts) hose clamps. How do you access these hoses?


Can you bypass the heater core on a 1997 crown vic?

Just take one of the heater hoses loose at the heater core and loop it back to the motor to the other heater hose. Or you can take them both loose at the heater core and put a splice connector between them is this is easier.


How do you change heater coil for ford expedition 1997?

the HEATER CORE can be removed by removing the dash. how do i ghange the dash


How do you take off a heater core on a 97 Pontiac grand am?

How to change a heater core on a 1997 Pontiac grand am


How do you troubleshoot heater not blowing warm on 1997 Nissan 200SX SE 1.6L?

Assuming the blower motor is working but the heat is poor, run the engine up to operating temperature, leave the engine running, heater on, in park with parking brake set. Get out and open the hood. Locate the heater hoses going to and from the heater. Using your hands feel each heater hose one at a time. If one hose is hot and the other is cool or warm, you probably have a plugged heater core. If both hoses are only warm, you may have a faulty thermostat. If both hoses are hot, you may have a malfunctioning temp blend door. If the car has a cabin filter be sure to check it or change it, it may be plugged up with debris.


Why would your 1997 Chevy silverado heater not be able to switch the airflow between floor defrost vent or mix?

If your Silverado is like most other cars today, it will use vacuum hoses to change the distribution between each setting. The vacuum in the hoses is created usually by the engine, and transferred to the switch you use in the cabin. Now if there is a slight split or crack in one of the hoses or one is loose this will lose the vacuum, which is why it will not change setting because there is no negative pressure to force the setting to change.


Where are the heater hoses on a Chevy Venture 1997?

Not a fun job to do... They come from the heater core located on the passenger side of the firewall. becasue it's a Chevy Venture/Olds Silhouette/Pontiac Montana... this job is not easy.


Where is the heater control valve on a 1997 ford ranger 4-cylinder?

The heater control valve is on the left hand side of the engine bay, under the air intake duct. it has two heater hoses running to it and one vacuum line running to it.


How to change out heater core 1997 Chevrolet lumina?

Drain the water from your 1997 Chevrolet Lumina cooling system. Remove the water supply lines to your heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.


How much anti-freeze does a 1997 olds bravada take?

The cooling system (heater, radiator, engine and hoses) holds aprox 12 qts.


How do you change a heater core in a 1997 ford F-150 truck?

Step one, remove the dash completely. Two, remove the upper portion of the heater box. Three, remove the heater hoses. Four replace the core. Five, reassemble the vehicle. Good luck with step one. Is this the best you can do with an answer I'm disappointed in your answer their is a better way and this is not it thanks for nothing


How do you bypass the heatercore on a 1997 sunfire gt?

connect a piece of heater hose from the thermostate housing (where one of the hoses connected to from the heater core already is) to the connector for the coolant at the bottom of the enigine (where the second line should be connected).


If you bypass the Heater Core on a 1997 V8 Ford F150 what will the consecuenses be?

If you bypass it correctly you will just no longer have any interior heat. Simply disconnect the heater hoses and connect them together. Connect the Inlet hose & Outlet hose going to the heater core together using a connector that you can purchase at most auto parts stores. By doing this you are simply routing the coolant away from the heater core. WARNING: Do not plug either of these hoses!!!!