answersLogoWhite

0


Best Answer

I just changed the ignition switch on my 96 Ranger. After removing the steering wheel housing with a Philips driver (3 screws), turn the key to the on position, locate the pin hole (on the bottom) and use a paper clip to press the small release button, and the unit should slide out. After I replaced mine, I can now start the engine but not cut it off and the radio and accessories stay on draining the battery. Any other suggestions.

I just changed the ignition switch on my 96 Ranger. After removing the steering wheel housing with a Philips driver (3 screws), turn the key to the on position, locate the pin hole (on the bottom) and use a paper clip to press the small release button, and the unit should slide out. After I replaced mine, I can now start the engine but not cut it off and the radio and accessories stay on draining the battery. Any other suggestions.

User Avatar

Wiki User

โˆ™ 2011-09-13 00:23:15
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the ignition on your 1996 Ford Ranger?
Write your answer...
Submit
Related questions

Install ignition 2002 Ford Ranger?

install ignition 2002 ford ranger directions


How do you change a fuel filter on 1996 Ford Ranger supercab?

where is the fuel filter located on 96 ford ranger supercab


1996 ford ranger xlt has no heat how do you fix this?

change the thermostat


Where is the ignition control modular located on a 1996 ford ranger?

I believe under the distributor . It should have a plug attached to it.


Where is the ignition module located on a 1995 Ford Ranger 2.3L?

The 1995 Ford Ranger ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


Where is the ignition module located on a 1989 ford ranger?

The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


Why won't a 1996 Ford Ranger 4.0L start with a new solenoid?

where is the fusible link on a 1996 ford ranger xlt


How many plugs 96 2.3 ranger?

The 1996 Ford Ranger 2.3 L engine has Fords Twin Plug ignition system , so it has ( 8 spark plugs )


Does a 2000 Ford Ranger have a distributor?

No , the engines in a 2000 ford Ranger are E.D.I.S. ( Electronic Distributorless Ignition System )


How do you change a 1993 Ford Ranger clutch?

how to i change a clutch in a 1993 ford ranger


What is the oil capacity with filter for 1996 Ford Ranger 3.0?

4.5 U. S. quarts ( 4.3 liters ) with filter change for the 3.0 L - V6 engine in a 1996 Ford Ranger ( according to the owners manual )


Which fuse for cigarette lighter Ford Ranger 1996?

( # 17 ) is a 15 amp fuse for the cigarette lighter in a 1996 Ford Ranger


Where is the shift solenoid located on a 1996 Ford Ranger 4.0?

where is the shift solenoid on a 1996 ford ranger 4x4 with a 4.0 v6


How do you replace the speedometer cable on a 1996 ford ranger?

1996 ranger does not have speedo cable it is electronic


Will a thermostat for a 1996 Ford Ranger fit in a 1993 Ford Ranger?

yes if the motors are the same.


Extr stomped you need the best and brightest 1994 ford ranger ignition problem httpanswersedmundscomquestion-extremely-stomped-you-brightest-1994-ford-ranger-ignition-starting-problem-45005aspx?

This makes no sense. What is your question?


Does a 1996 Ford Ranger have a passenger side airbag?

A 1996 Ford Ranger could be equipped with a passenger side airbag ( SRS ) * so maybe yes and maybe no * All the 1996 Ford Ranger models have a drivers side airbag


How do change an alternator on 1996 Ford Ranger?

Remove the alternator belt from your 1996 Ford Ranger alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.


1996 Ford Ranger have a DPFE SENSOR?

YES - www.motorcraft.com lists a DPFE sensor for all available engines on a 1996 Ford Ranger


Will a 1996 Ford Ranger transmission fit on a 1989 Ford Ranger?

what does a fuel pump look like in a 1989 ford ranger 4 cyl.


How do you change the ball joints in a Ford Ranger?

1998 2wd What year? 2WD or 4WD? 2WD 1996


What color is the ignition wire for a 2001 Ford Ranger?

The ignition wire for the 2001 Ford Ranger is yellow. This is the 12 volt constant wire. Other wires in the harness are red and blue.


How do you change dash lights on a 95 Ford Ranger?

How to change dash lights on a 95 Ford Ranger?


How do you bypass anti-theft system on Ford Ranger?

How do you bypass the alarm on a 2000 Ford ranger cause I replaced the ignition


Will 1996 Ford explorer fit a 1996 Ford ranger?

What part? Not many parts are interchangeable.