Remove steering wheel. Underneath is the turn signal switch. There is a ring around the steering shaft holding the steering wheel lock plate down. Push down on the lock plate and remove the ring and the lock plate. Next is the turn signal switch. 3 screws holding it down one on the right side above the key and 2 on the left. Probably have to move the turn signal switch left and right to get them. the arm is held on with one screw. Remove the hazard button, one screw in the end of it. There should be enough slack in the turn signal wires to get it over the steering shaft. On the top side at the bottom of the ignition switch there should be a screw. Remove screw and the ignition switch will just pull out. Reverse to install.
i have 85 cavalier how you get key cycliner out
How to drill out ignition switch on 1985 ford f150?
Remove the retaining ring at the top of your 1985 Chevy ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
You're going to have to unbolt the steering column and drop it down. The ignition switch will be on the top of the column along with your high beam switch. Unbolt the switch then unplug it.
The 1985 Chevrolet El Camino ignition switch can be removed by loosening the retaining ring at the top of the switch. The switch will slide out. Remove the wiring harness from the back of the ignition switch.
replace ighnition switch for 1985 chevlot
top of colum under dash
The turn signal/wiper switch is most likely bad and will need replacment. how do you change the switch is it necessary to remove steering wheel?
Remove the switch by boring out the rivets holding it in place. The cylinder will come out easily once you get the lock free from its casing.
The actual problem is the starter continues to turn after key is turned off and pulled out of ignition.
it could be something wrong with the ignition switch, and or alarm
The main Ignition wire from the switch is dark blue, look under your steering column, and there are screws to separate a piece of plastic, directly behind your steering wheel, and you will see the dark blue wire coming from the switch