The proper way is right under the outside plastic handle - there are the two lights, they need to be "pressed" toward the front of the car to release the tab, comes right out. Snaps right back into place... remove the interior tail gate pannel. Replace bulbs from the inside.
you need to remove the inside panel to get to these bulbs
They are located inside the trunk lid, underneath the felt lining. You need to unsnap and pull back the felt lining to access the bulbs for the license plate light.
From inside the trunk,twist the socket counterclockwise to remove the socket...
Replacing license plate lamp bulbsThe license plate bulbs are locatedbehind the rear bumper. To changethe license plate lamp bulbs:1. Reach behind the rear bumper tolocate the bulb.2. Twist the bulb socketcounterclockwise and carefully pullto remove it from the lampassembly.3. Pull out the old bulb from thesocket and push in the new bulb.4. Install the bulb socket in lamp assembly by turning it clockwise.
Change brake light bulbs Just remove the rear license plate. You can change the backup lights and brake light easily.
From the outside of the car.. Just un-screw the two screws and change the bulb.
Changing the license plate bulb on a 2002 Lincoln LS is quite simple. You must first remove the license plate first. Then unscrew the old bulbs and screw in your new ones.
through the rear package compartment under the matting
There are plastic bulb covers on either side of the license plate. Unscrew the screws and take the covers off. From there you can insert new bulbs.
They are located inside the trunk lid, underneath the felt lining. You need to unsnap and pull back the felt lining to access the bulbs for the license plate light.
the plug on the back side of the bumper twists to the left and you pull it out of the bumper
from inside the trunk pop all of the plastic rivots and you can access the bulbs from the inside..
Check bulbs
Well if you open your trunk you will be able to access your plate bulbs and help you change them with ease.
there are 2 license plate bulbs-look up above license plate,see 2 lens covers.remove with Philips screwdriver and pull bulbs out of sockets.i just did it t'nite but the lites still don't work.may be short or broken wire-perhaps where wires go thru liftgate opening...haven't checked yet. look for simple solution...bulbs 1st!
There are two housings above the plate all you need is a Phillips head screw driver remove the 4 bolts and change the bulbs it's that easy
let your dealership fix it. 4yr 60k mile warranty on those bulbs
The clear covers for the license plate light bulbs have small arrows pointing in one direction. Simply push the cover to the direction of the arrows and the covers will slide off allowing for the old light bulbs to be replaced.
in the rear facia, under the trunk lid there is 9 bolts holding the facia on. You must remove the nuts and pull the facia out and right above the license is the two bulbs 194. replace the bulbs and put the facia back on and you are on your way.
On top of the license plate is a clear plastic lens with 2 screws in it. Take it off. Then a bulb slides into the holder, then replace the lens. There are 2 bulbs. One on each side.
Open your trunk the two inner bulbs are for your license plate twist and should pop right out
How do you change the lamp on the license plate of a lincoln ls 2000?
bend over sheave it up ur asss
· lugnuts · light bulbs · license plate holder
On my Escape XLT, you reach up under the front license plate. Ther cord is there with a nice cap on it. On my Escape XLT, you reach up under the front license plate. Ther cord is there with a nice cap on it.