yes
To change the light bulb for the ashtray in the 1999 Volkswagen Passat, the ashtray has to be taken out. The bulb can be accessed just under the dash near the ash tray.
could be the alternator going bad or battery.
1. Remove ashtray. 2. Remove ashtray track assembly (two screws underneath). 3. Replace bulb. 4. Install ashtray track assembly. 5. Insert ashtray.
They are commonly referred to as filler panels.
at least on a 79 fleetwood it is located in the light switch itself
There are several torx head screws around the rim of the lens. If it just one of the bulbs that needs changed and the screw heads are stripped, you can get to the bulbs by reaching under the tail fin and into the back of the light.
Disconnect negative from battery remove four clips from ashtray disconnect lighters and bulb reverse procedure for install
change backup light 2002 cadillac deville
Take the 2 screws out on the sides of the housing,then lift it up,disconnect the wiring from underneath...then remove the 2 srews from under the top ...separate the parts to access and change the bulb....reinstall in reverse order....
this one is easy.....put the car in the on position(not running) and within 5 sec tap the gass pedel to the floor 3 times. the light should blink when taken(doesnt always on mine though). that should reset it! 93 fleetwood brougham.......d-body
I just changed the ashtray light in my 2000 Windstar LX. It is probably similar. Open the ashtray. Take a regular screwdriver and insert it between the top of the ashtray and the dash board in the center of the ashtray. There is a latch hidden there. Lift the screwdriver handle, which will press down on the latch. Then simply pull out the ashtray. It will be connected by the wires for the light. You can either disconnect the wires or carefully turn over the ashtray. When you turn it over you will see the light assembly attached to the wires. It snaps out of the ashtray. Then you can remove the light from the assembly by releasing the latches of both sides of the assembly. Then the light pulls straight out. Putting it back together is a little tricky. Once you have the new light installed and the light assembly put back together you need to reinstall the light assembly. This is a bit of trouble. Perhaps putting a piece of scotch tape around the assembly will help to get it aligned. It snaps back into place. Reconnect the wires if necessary and reinsert the ashtray.