UNLESS YOU'VE NEVER DONE BALL JOINTS -------DON'T----------- IF YOU DON'T KNOW WHAT YOUR DOING - THE COIL SPRING CAN -KILL YOU- Find somebody that has, there is MANY THOUSANDS of POUNDS of PRESSURE (if) the Vehicle ISN"T jacked up correctly.a Ball Joint Press is the best,but a Large socket & a large hammer is one way IF U have done it B 4.
How do you change the lower ball joints on an 2004 envoy
take old ones out... put new ones in
If its 2 wheel drive, you will need a press. Those ball joints are pressed into the upper and lower control arms. If it is 4 Wheel drive you need to remove the rivets with either an air chisel or to drill them out.
You change the control arms, upper and lower. The ball joints are manufactured into the control arms.
Lower the steering column.
You have to change the whole lower control arm.
How to change upper and lower ball joints on a 1997 ford explorer all wheel drive?
It's on the lower right side of the block
The ball joints are riveted or pressed into the upper and lower control arms, then the spindle is bolted to the ball joints.
Change lower ball joints on a 96 gmC 4 by 4
They are exactly the same.
WWW.AutomotiveFourms.com
9 to 13 LBS. No lower are higher are you will have starting and running problems.
9 to 19 PSI. / LBS. NO lower are higher are you will have problems.
If it is a 4+4, the lower ball joints wear quickly.
NO, it has upper and lower ball joints on each side that hold the spindles in place.
how do i change a lower ball joint on a 1992 ranger 2wd
You can not just change the ball joint , you have to replace the whole lower control arm with ball joint.
Try the lower rear of the engine - try to follow the + battery cable
The lower ball joints have to be pressed out. The upper ball joints are part of the control arm, so the complete upper assembly has to be replaced.
Uncovertebral joint arthropathy is a degenerative change of the uncovertebral joints. These joints are small synovial joints between the lower cervical vertebrae and the superior vertebral body.
9 to 13 LBS. NO higher and NO lower. MUST be within specs.
9 to 13 LBS. It can NOT be any higher are lower are you will have troubles.
Drive it to the local garage and pay to have it done.
What year, if it has upper it has to be pre 1989