I am assuming that you mean the main seal on the crankshaft. Generally replacing the main seal requires that the crankshaft be removed. Which usually means the engine has to come out. I don't know anything about the 3.0l engine. Any of the vehicles that I owned that had a main seal leak never got changed.
Yes, any 2.8 will fit in a transformer.
where is the fuel filter located on a 1990 ford ranger 2.3 L engine
where is the PVC valve located on a 1990 ford ranger 2.3 L
You can get one from any ranger or explorer 94 or below, and it can come fromany 2.9,or 4.0 engine
The 2.9 liter V6 engine in a 1990 Ford Ranger has a timing CHAIN
Can you change a automatic to a 5 speed Honda Accord 1990
The only speed sensor on the engine is inside the distributor.
how do you change outer tie rods on a 1990 ford ranger
According to www . the ranger station . com ( no spaces ) Click on TECH LIBRARY The 1990 Ford Ranger with the 2.9 liter V6 has either the Mitsubishi FM-146 ( 4X4 ) or the Mitsubishi FM-132 ( 2 wheel drive ) five speed manual overdrive transmission Both transmissions take 4.8 pints of ( 80-90W gear lube )
Ford offered two transmissions that year. A 5-speed manual transmission was standard with the 2.3-liter, four-cylinder engine as well as with the 2.9-liter, V-6 engine. A 4-speed automatic was optional. A third engine, a 4.0-liter, V-6 offered the 4-speed automatic transmission only.
The 1990 Ford Ranger 3.0 liter V6 engine has a distributor , the 2.3 liter - 4 cylinder and the 4.0 liter V6 have EDIS ( Electronic Distributorless Ignition System )
or what will make the 1990 jeep wrangler 4.2 and 4.0 engine swap out
Have vehicle scanned to determine the problem
underneath the engine compartment fuse box on passenger side
I don't know how that is why I asked the question.
You do not remove the engine to change a water pump.
A 1990 Ford Ranger is OBD I / EEC IV - if that's what you are asking
location of fusable links Ford Ranger 1990 2.9
Moon Ranger happened in 1990.
Moon Ranger was created in 1990.
You drain coolant from the radiator. but according to the book ther are two plugs on the engine block that need to drain the coolant from.
change the motor or engine
is there a picture of where the horn fuse is located on a 1990 ford ranger