0
I am guessing the yours is either dead or it is bouncing around. 1. It is located on the back side of the engine. Looking from the front it will be on the drivers side, with three wires hooked to a plug on the sending unit. 2. Once removed and ready to install the new one, coat the threads with a Teflon pipe dope and screw in. You might have to remove the Distributor cap to get better access to the sending unit.
What else can I help you with?
What year Chevy 350 engine do you have?
where are the temperature sending unit located on a 1990 Chevy engine 5.7
Does a 1990 Chevy Silverado have a fuel sending unit?
Yes, it's in the fuel tank.
How do you change the starter on a 1990 Chevy Corvette?
== ==
How do you change a turn signal on a 1991 Chevy Lumina?
how can i change the turn singal on a 1990 Chevy lumina
Oil sending unit 1990 Chevy location?
It is right behind the distributor, screewed into the top of the engine block.
What color wire is hooked to oil pressure sending unit on 1990 Chevy truck?
There is only one wire and it should be black.
How do you change a fly wheel on a 1990 Chevy silverado 2500?
The transmission must be removed to change the flywheel.
Where is the temperature sending unit located on a 1990 ford f-150 350 cu in?
fords don't have a 350 the 350 is a Chevy motor
How do you change the oil sending unit on a 1990 Chevy Silverado half ton 350 cu in and where is it located?
The oil pressure sending unit on my 1997 silverado is on the top of the engine behind the intake manifold. It took a while to find it.I had to climb on top of the engine and look down to the block up near the firewall I was having eratic oil pressure readings and the sending unit was the problem.
How do you change a timing belt on a 1990 Chevy caprice classic 350?
It does not have a timing belt. The cam is chaindriven.
How do you remove the oil sending unit on a 1990 Chevy Corsica 3.1 ltr?
unhook the wire, screw the whole sensor out then thread the new one in and hook up the wire
Where is the Oil Pressure Sending Unit located on a 1990 4.3 Chevy S-10 Blazer?
The oil pressure switch is directly behind the carburator. Between the distributor and the carb.
