I unbolted the cover on the wheel well and reached in to change my signal lights. Then I bolted it back on. I hope this works.
check dimmer switch for headlights
When changing the corner lights on a 1992 Acura Integra first find the housings for the corner lights. Pull the old lights off and replace the bulbs.
Well if you pop the hood and look above the headlights you will see a screw. It may be a hex screw. Now if you need to raise the lights tighten the screw and if you need to lower the lights, loosen the screw.
You can put blue film over your headlights but you can not change the lights to be blue. It is illegal. Only emergency vehicles can have blue or red lights.
Well, from what i understand of your question i think you are askign how to change front brake lights and corner lights. These are headlights and corner lights, brake lights are located at the rear of the car. Pop the hoos, you should see the wiring that hooks up to the lights. Unscrew the plastic"shield" that protects the bulb and change the bulb place it back in and screw the light back into place. (i recommend checkign to make sure the light bulb works before putting it back in the whole light) Good Luck.
Probably a fuse that has expired, change it.
Headlights, interior lights, parking lights,Headlights, interior lights, parking lights,
The ground ciruit for the headlights is by way of the headlight switch , the lights always have power
cavalier break lights not workin no indicators neither help fuseis gud do i need to change panals were bulbs go or what????????????
Check the starter motor, is it an auto?
I have a 2000 Cavalier that did the same thing with the DRL, and only one of the lights worked when I put on the headlights manually. Ended up being a burnt-out bulb that I had to replace. No wiring necessary.
Check the fuse for the headlights. It is probably open.