answersLogoWhite
Ford Probe
Toyota Tacoma
Ford F-150

How do you change the parking light assembly on a 1993 Ford Probe?


Top Answer
User Avatar
Wiki User
2011-09-13 00:24:48
2011-09-13 00:24:48

For the rear light assemblies there is one screw. Open the hatchback and on the inside top edge of the assembly, remove the one Philips head screw. You will also see a couple of slots next to the body. Stick a flat blade screw driver into these slots between the body and the light assembly and pry out on the assembly. It will pop out from the body.

Related Questions

User Avatar

you have to remove the headlight assembly 3little bolts

User Avatar

This was answered last week and is a simple procedure. One Phillips screw holds the parking light on in my 2000 Forester. You open the hood, remove the screw, pull the lamp assembly out and you have access to change the bulb. If you are asking about changing the whole assembly, the answer is the same. --Ken

User Avatar

The are two Phillips head screws below the parking light assembly that are attached to the splash guard, remove the two screws and then parking light assembly should pull out from the header panel.

User Avatar

Remove the headlight assembly and you will have access to the parking light bulb.

User Avatar

I believe it is 2 torx screws inside the tailgate holding the assembly. Have to replace the whole assembly.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.