Disconnect the battery and just remove the bolts holding the alternator, disconnect the wire connection and remove the alternator.
Disconnect the battery. With the care safely raised, remove the two bolts holding the starter on. Disconnect the wires. Reverse the procedure to install the new starter.
disconnect the battery, then the wires from the starter. Then remove the bolts holding the starter to the engine.
disconnect neg.cable,then disconnect pos. cable from starter ,then other wire,then remove 2 bolts holding starter to engine.
The sensor will either screw in or have a bolt holding it. Disconnect the wiring plug then unscrew or remove the bolt to change.
How do you change transmission in a acura legend?
I believe it is 2 torx screws inside the tailgate holding the assembly. Have to replace the whole assembly.
Drain the old one, disconnect the transmission lines, undo the radiator hoses and bolts holding it in an pull it straight up.
Disconnect the four plastic screws holding the plastic plate in the back of the trunk. This exposes the tail and brake lights.
Disconnect the electrical plug, remove the two small screws holding it in place then remove the resistor.
how do i change a parking light bulb on a 2003 hyunadi accent
To change the voltage regulator on a 1995 Ford Thunderbird, first you will need to disconnect the battery cables. Then, remove the bolts holding the regulator to the frame of the vehicle and the wires connecting it.
If you change the colours for the items on the chart that the legend is showing to have shading, then you the legend will change too. You can also change the background of the legend itself, by right clicking on it and select the Format Legend option and then the Fill option.
To change a fuel vapor sensor on a 1997 GMC Sonoma you need to disconnect the wires that are holding it in place. Next, remove the old sensor and replace with the new one.
Disconnect the battery. The starter should have two or three bolts holding it in. And there will be wires connected on it. Loosen the bolts and wiring connectors, then remove the starter from its mount.
Starter replacement is fairly simple. Located on pasenger side, access from under the car. Disconnect battery first, disconnect wiring to starter, then remove 2 bolts holding starter to engine case. Install new starter, reassemble in reverese order.
1.Disconnect negative battery cable. 2. Climb underneath and locate the starter. 3. Disconnect cables and wires on starter. 4. Remove bolts holding starter in place. 5. Remove starter. Installaton is REVERSE of removal
Disconnect your battery first. Then remove the belt you can buy or borrow a tool for the tension pulley or use a long bar just be careful where you rest it. Remove the nut on the back of the alternator holding the power wire then remove the to bolts holding the alternator.
It does no harm to disconnect the battery when working on a vehicle but in general no, you do not need to disconnect them to change a filter.
Disconnect battery, remove wires off of starter remembering where they go, then loosen two nuts holding the starter . Reverse to re connect/install
Select them and right click on them and you can change the settings of them. If you change the colours of things on the chart, the legend colours will also change.
When/IF you can change the settings it will disconnect you without a cable
HOW TO FIX A PARKING LIGHT ON A 1996 TOYOTA COROLLA