answersLogoWhite
Chevy Venture

How do you change the positive battery cable on a Chevy Venture?

464748

Top Answer
User Avatar
Wiki User
2007-05-01 00:46:47
2007-05-01 00:46:47

1. Disconnect the battery ground cable. 2. Disconnect the battery positive cable. 3. Remove the battery positive cable nut from the accessory wiring junction block. 4. Remove the battery cable from the starter motor BAT terminal. On the 2002 Venture, The positive battery terminal also supplies power to the circuit breaker and relay assembly located at the left corner of the engine compartment right over the battery. The battery cable for this vehicle is a "factory only" replacement part and is very expensive, in the neighborhood of $130.00 and tax. A perfectly satisfactory alternative is to use a generic battery cable of the right length connected from the battery to the starter motor, and a generic battery cable with ring terminals on both ends connected from the starter motor back to the circuit breaker/relay box. This alternative is an exact electrical equivalent of the factory part, works great, and saves a bunch of both time (ordering part) and money. Good luck!

1

Related Questions

User Avatar

The location of the battery on a Chevy Venture is under the hood. It rests under the cross bar, which has to be removed to replace the battery.

User Avatar

How do you change rear brake drum on a 2004 Chevy Venture?

User Avatar

you have to take out the fuse box, then take out the bar , then you can take out the battery.

User Avatar

i was wondering how to change rear brake drums for 1999 Chevy venture

User Avatar

first remove the cables from battery, neg, than positive, remove hold down bolt on bottom of battery. remove battery.

User Avatar

Alternator is going out? battery is going bad?

User Avatar

this happen to me and turned out to be corrosion on battery terminal, clean them very good.

User Avatar

Remove the bolts that hold down the battery, remove the negative, remove the positive, and then pull it out. To install, do the following steps in reverse order.

User Avatar

unhook the positive on the battery for 5 min. This should reset your check engine light if it doesnt then you still have issues.

User Avatar

At least on a 2003 Venture, there is a door in the back of your glove box that opens where the air filter is at to change.

User Avatar

Disconnect the battery, remove the spark plug cables and boots, and remove the old spark plugs. Put in the new spark plugs, attach the boots and cables, and connect the battery.

User Avatar

To change the muffler or exhaust in a Chevy Venture, jack up the vehicle and locate the muffler. Spray penetrating oil on the nuts and loosen muffler clamps. Replace with new.

User Avatar

What is the easiest way to replace the starter motor on a 2000 chev Venture?

User Avatar

I've got a better question, why is this question in the Chevy venture forum ?

User Avatar

Remove the positive battery cable from your 1997 Chevy Blazer battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install the new starter.

User Avatar

Remove the positive battery cable from your 2000 Chevy Malibu battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

User Avatar

Disconnect the battery for approximately two minutes.

User Avatar

How do you unlock the radio of. 1997 Chevy venture

User Avatar

Follow the positive battery cable from the battery, it will lead you right to the starter.

User Avatar

You don't need to get to the negative side of the battery. If it's hidden or difficult to reach, you can just connect the negative side of the charger to any solid metal structure on the body or engine.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.