Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.
.The 2000 Chevrolet Monte Carlo brake caliper bolt size is 9/16. The brake caliper bolt can be purchased at most auto-parts stores
You may have to change the sensor, it's a $9.00 part at autozone.
ratchet or socket
* It could be a blown fuse or * the brake light switch on top of the brake pedal under the dash is bad or * the turn signal switch is bad.
Remove the tire and wheel. Remove the brake pad springs and hardware. Remove the brake rotor. Reverse the process to install the new brake and rotor.
Brake light switch on the brake pedal is defective
check your break fluid.
It should be in the fusebox with the rest of the fuses.
on top of the brake pedal under the dash.
If your 98 Monte Carlo brake lights do not work when you hit the brakes, but the top one behind the glass works, check the bulbs. If the bulbs have burn out, the lights will cease to work.
If the bulbs are good then the brake light switch is bad, it's on top of the brake pedal up under the dash.
possibly, if there is a float attached to the lid, another cause of the abs light is metal shavings sticking to the magnetic sensors
1995 Chevrolet Monte Carlo no tail lights or dash lights they will come on at time and go off the fuses are not bowed. The tun singles and flasher and brake light work. What should I look for now?
The 2002 Monte Carlo blinker flasher relay switch is located beneath the drivers side dashboard. The blinker flasher relay switch will be above the brake pedal.
same as the old lines, just get straight brake line and bend it like the old as you go.
DOT 3 brake fluid as listed on the master cylinder fill cap.
my 95 montey Carlo is doing the same thing, and it is the turn signal switch assembaly,
no, just one solid one, also used as the blinker.
Most likely cause is a build up of brake dust.
The rear brakes on a 2001 Monte Carlo are replaced by removing the rear wheels, unbolting the calipers, and taking out the old brake pads. The new pads can then be installed and the brakes reassembled.
as far as I know, left side of the steering column. At least, on the column somewhere.