How do you replace the blower motor on a 1994 chevy lumina euro?
Yes it will, I did the interchange on mine
Sorry But You Will Have To Remove The Fuel Tank
Should be by the alternator in the back
the o2 sensor for a 1990 Chevy lumina euro 3.1l v6 is on the down pipe for the exaust just below the manifold on the back side of the engine, by the firewall
where is the fuel pressure regulator on1991 lumina 3.1 /
I doubt it
It's called the tunk lip!
your firing order is 165432
remove bolts and replace it how do u think
my 93 lumina was cutting out and i cahnged the fuel filter and spark plugs and it runs good
Remove the water return hose from your 1993 Chevy Lumina water pump. Remove the water pump belt. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
There is no cable....It's all done with a sensor and electronics.
I have a 93 euro 3.1 with 186k and am getting between 20 and 25 depending on how I drive.
Ticking in an engine generally refers to the valves. If ticking is apparent on a 1994 Chevy Lumina tighten the valves to factory specifications.
It is on the throttle plate opposite of the bellcrank.
Because you have a leak.
It is located on the firewall right behind carborator.
With a pry bar in the right spot and some leverage it will pop out.
I have a 1990 Lumina Euro and my starter is right down at the bottom of the engine in front of the car. If you get down under the bumper you can see it. Actually you can see it if you have some good light under the hood. Just raise the hood and look straight down between the engine and the cooling fans. Hope this helps.
EGR may not be working.
Check your fuses
it is at the end of the upper radiator hose inside the metal house the hose connects to
up with the radiator. in the very front of car. hard to see n find it's there!
I have a euro lumina and I have two there is one in the glove compartment one one under the hood on the right side of the engine on top. I hope that helps.