You will need to remove the panel liners inside both sides of the trunk. This will give you access to the top nut of each rear strut. You will need to remove the existing struts to place the new coil springs over the struts. You may need two jacks, one ot jack the car up and one to use to compress the coil spring you are installing. This takes about 1 and a half hours for both rear coil springs. I bolt on the bottom of the sturt and the nut inside the trunk is all you need to remove to get the struts off and replace the coil springs. Make sure you check the quality of the strut mount bushings (rubber gaskets) before you re-install. They re only about $10 a piece from the dealrer and worth the price if you are going to this much work.
No, they are too light to work on an Accord.
Use a strut spring compressor to compress the old spring, the remove the strut from the spring. Use the compressor to put the strut into the new spring. Install the strut and spring into the vehicle.
Replace
A Ignition coil diagram for 1991 2.2 Honda accord
Bad coil?
If the coil is bad you do not fix it you just replace it with a new one.
In the bottom of the distributor under coil.
there are four spark plug wires that run to the distributor..the fifth one is the coil wire
Bad coil? Bad Pick-up?
1992 dodge dakotas do not have front coil springs, they have torsion bars instead.
If you see no center coil wire connector then the coil is mounted inside the distributor. If there is a center coil wire connecter then follow the coil wire and it will go to the coil.
change front coil spring on 2000 Pontiac grand am