answersLogoWhite
Chevy Silverado
Dodge Stratus
Jeep Cherokee

How do you change the rear main seal in 1991 jeep Cherokee with a 4.0?

345

Top Answer
User Avatar
Wiki User
2010-02-11 12:48:59
2010-02-11 12:48:59

The oil pan must be removed along with the rear main bearing cap. The rear main seal is loacated under the rear main bearing cap.

1

Related Questions

User Avatar

It will cost you approximately $300 to replace the rear main seal on a Jeep Cherokee. The amount will vary slightly depending upon who does the work for you.

User Avatar

That's not what is leaking, & you'd have to pull motor to do it. These leak from the oil filter arm or the rear main seal.

User Avatar

The brake light fuse on a 2003 Jeep Grand Cherokee can be found by looking at the cover to the main fuse box. It identifies each fuse and its location.

User Avatar

I would imagine you have to pull the tranny and transfer case, Also that part of the exhaust just to access it.

User Avatar

The fuse for the fuel pump on a Jeep Grand Cherokee CRD is located in the engine compartment in the main fuse box. It prevents the pump from being overloaded and damaged due to a surge.

User Avatar

The fuel pump relay on a 1992 Jeep Cherokee Laredo is located under the hood. The fuel pump is located under the vehicle and is attached to the main harness.

User Avatar

Their are 2 main bolts that hold on a thermostat housing for an 1987 jeep cheorkee pioneer!!

User Avatar

The address of the Cherokee Main Street Program is: 121 East Main Street, Cherokee, OK 73728-0039

User Avatar

I have a 1996 Jeep Grand Cherokee that had the same problem. I found out it was a rod that went from the front right wheel to the main body, it's called a STEERING DAMPENER. After I replaced it she drives like a dream now.

User Avatar

mains 80 ft lbs rods 33 ft lbs main support brace 35 ft lbs

User Avatar

"Main fuse"? Fuses are located in the under hood fuse box."Main fuse"? Fuses are located in the under hood fuse box.

User Avatar

There isn't a separate computer for just the odometer. Attached to the firewall behind the coolant bottle is the main computer. There are 3 cables that plug into the front of the computer and the odometer is in there. When you buy a new or refurbished computer for your jeep you need the vin number and the odometer reading so the computer can be programmed for your jeep. Meaning the odometer reading is in the main computer

User Avatar

it is located under the hood in the main fuse box on the left hand side by the battery small black rectangular box

User Avatar

On the 2000 there are two filters. The main one is inside the tank and the second is an in line located on the rear passenger side near fender well.

User Avatar

Either near the hinge of the passenger door or under the hood in the main relay box near the battery.

User Avatar

No, but you do have to have the oil pan off, and sometimes it is easier to get the oil pan off if the trans has been removed.

User Avatar

....and your question is?

User Avatar

the main tribe was the Cherokee

User Avatar

A Jeep 4.0L has a two piece rear main seal. You have to remove the oil pan and rear main bearing cap to replace it.

User Avatar

"Yes, there is a JEEP dealer locator online. If you head over to the JEEP main website, a window will automatically pop up asking for your zipcode. From there it will direct you to a JEEP dealer near you!"

User Avatar

If you do it yourself, then it will only be the cost of the seal. If you have it done, then you'll have to call around for an estimate. If you have a manual transmission, then you may consider replacing the clutch and throwout bearing, since you're already there.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.