Remove the door panel.
open trunk there are six hand tightened plastic wing nuts undo all of those the entire assembly will come off then you may change bulbs
The side marker bulbs on a 2002 Buick LeSabre are replaced by removing the retaining screws and disconnecting the wiring harness. The old bulb can then be removed and a new bulb put in its place.
Changing a headlight bulb in a 2007 Buick Lacrosse can be done easily. Just remove the cover piece and change the bulb.
Changing out side marker bulbs are easy. All you have to do is unscrew the old one and screw in the new one.
You have to remove front headlight piece (which is held by two screws). Once removed you will be able to see and reach the bulb connection on the back of the side marker.
It should be the same type of bulbs that are in the side marker lights. They should be #194 bulbs if memory serves.
There's one little part of the assembly that tabs-out and you can easily get to the bulbs then.
IT not to hard to change .take the Phillips screw out on the side of the marker lamp then open the hood and open the plastic black door behind headlamp. you will need a 11 millermeter wrench or socket .take the bolt off the back of the marker lite and it will come right out.
There are many bulbs on a vehicle, need to know which bulbs you want to change.
very carefully !! Read your owners manual and do it very carefully -those bulbs are VERY very cheap if broken !!
Front marker lights can be changed by removing front headlight assembly. To remove pull up on two metal clips behind light assembly and unplug wires. The side marker lights are now accessable. Turn bulb socket ccw to remove.
There are no bulbs, it is a panel of mini-lights. You access this from the trunk area.
I changed the marker light today on my 98 Ford Ranger. There is two screws under the park light. Take both screws out and pull on the marker light and the park light at the same time. It will all come out at one time. That gives you axcess to your bulbs.
you open the trunk. Pull back the carpet covering the back side of the taillights. Remove the plastic wing nuts, about six or eight. Slide the whole taillight assembly to the rear. The bulbs pop out of the assembly for an easy replacement.
You have to open the hood, unscrew the front turn siganls, remove the bulbs, remove the bolts holding on the grill, release the 2 bottom tabs of the grill(through the turn signal holes), make sure marker lights are disconnected and remove the grill. undo 4 bolts on each headlight assembly and remove/change/replace the bulbs. Intallation is reverse.
The headlights are bulbs that insert into the glass from under the hood. One is behind the battery. They turn 90 degrees and pull out. They can be tiresome to try to change
It depends on which bulbs you're asking about.
If you can not remove fasteners on outside, you may need to cut a section out of the inside of trunk to get your hand by the bulbs.
I am answering my own question,, as I never received a response.. but it's fixed now,, ,,and in case someone else needs the fix,, The Dealer changed the bulbs during a tire change.. Mechanic had to reach up and over the fender housing while the car was on the rack.. . It's not realy an owner fix.. DM
you can, but you need to be fairly good at soldering as they are soldered on the board. Find the correct size bulbs will be a challenge also. Buick had a better idea. No wonder thy went broke
How do you change the light bulbs in the instrument panel in 1998 Toyota corolla
why should we change away from using incandescent light bulbs
Blown fuse/? blown bulbs /?bad flasher.
Did you check the bulbs?