You will need a 15-T (Torx) bit to remove the screws that hold the light box. Then push slightly down and pull out. This requires some force.
Hope this will help.
Both sides are removed by opening the rear gate, (look into the hinge area for the driver's side) you will see two Torx screws T-15 or so. Remove these, then gently pull the tail light assembly out.
The instructions for replacement of 2002 passenger's side rear stop light bulb (which follow the instructions for driver's side and are the only ones I could find online for passenger's side) do work, and for the 2003 model. It's a little scary to pull hard enough to separate the assembly from the car body, so it was nice to find the instructions saying that that's what you have to do. It's because once you take out the 2 screws on the left side of the assemply, the unit is still held in on the right side by a couple of plastic things that go into holes; they pop out (and later pop back in again) with pressure.
See the amswer for "How do you change the rear stop light bulb on a 2002 Jeep Liberty passenger side". It works.
the answer is no. 2002 was the first year the liberty was made. in 2003 they change the computer modules..the only engine you can put in a 2002 jeep liberty is a 2002 engine
The brake light bulbs ar removed from the rear of the light assy . Take it off of the body.
There is a single screw that is easy to remove. The trick after that is to take a screwdriver, wrap it in a cloth to avoid chipping your paint, and pry off the light cover. It will feel very tight, but it will pop off and can be easily put back on.
How do you change a tag light on a 2002 impala
change backup light 2002 cadillac deville
how to change a brake light on 2002 Nissan altima
Your question makes no sense, a 2002 Liberty will always be a 2002. You can not make it any other year.Your question makes no sense, a 2002 Liberty will always be a 2002. You can not make it any other year.
how to repair drivers side manual window for 2002 jeep liberty sport
Begin by removing the 2002 Jeep Liberty shift console retaining bolts. Lift the shift console up and the light bulb will be visible. Take hold of the light bulb, push in and turn at the same time to remove it. Reverse the process to install your new shift console light bulb.
what to do when the malfuction light comes on?
How do you turn off the change oil light on a Chevysilverado 2002
In the fuse/relay box located under the drivers side of the dash.
www.vwvortex.com they have the answers, you have to power
You have to cange the whole light.
it could possibly be in the fuse compartment located on the drivers side under the hood.
Click on the link to your right for more information.
There is a malfunction in the "chip" key system.
You can unhook the battery or use a scan tool.
2002 jeep liberty part time light wont turn off
Open drivers door and remove cover near light swicth.
Scan tool, will give you a trouble code as to why the computer turned the check engine light on.
you might need a new part. ;3
A 2002 Jeep Liberty has a timing chain.