Brake Pads and Rotors
Chevy Lumina
DIY Projects

How do you change the rotor on a 1998 Chevrolet Lumina?

141516

Top Answer
User Avatar
Wiki User
2008-06-04 06:28:50
2008-06-04 06:28:50

you need a special GM tool , a star design socket. This will remove the two large bolts holding the caliper mount to the chassie. I am in the process of replaceing three wheel studs , but first have to remove the rotor.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

under the engine on the passenger side.

User Avatar

it depends on where you bring it or if your doing it yourself.

User Avatar

Is there a Repair Manuel for a 1998 Cherolet Lumina?

User Avatar

For the Lumina car, it is located on the firewall basically centered behind the engine. It is a little rubber elbow coming out of the firewall. It drains directly from the elbow and the elbow can be removed and unplugged.

User Avatar

does the 1998 Chevy lumina have a fuel shut off switch

User Avatar

I have a similar question, did you find out?

User Avatar

On a 1999 3.1L v6 we get ~24mpg, www.fueleconomy.gov has listings if you need more accurate data or have a different engine.

User Avatar

The EGR valve is located on the top of the engine. Drivers side at the back of the engine. It is held on by two 10mm bolts.

User Avatar

The spark plug gap for a 1998 Chevy Lumina (with 3.1L or 3.8L engine) is .060".

User Avatar

where are the ports to recharge the air conditioning on a 1998 chevy lumina car with a v6?

User Avatar

My 1998 Chevy Lumina has air conditioning. I assume that was the question if Luminas come with a/c.

User Avatar

Remove the 2 bolts from the caliper and then the 2 to the caliper bracket and just take off your rotor. Installation is in reverse of removal. Just make sure to put anti-seize on the bolts before putting them back in

User Avatar

just a small side post 500 cold crank amps should be just fine for the 3100.

User Avatar

1998 Chevrolet Blazer did not have vent windows.

User Avatar

replace the starter on a 1998 Chevrolet cavalier

User Avatar

IT ALL DEPENDS ON WHAT ENGINE IS IN THE CAR. JUST A VERY ROUGH GUESS ABOUT TWO HOURS LABOR AND ABOUT 95 TO 125 BUCKS FOR THE STARTER

User Avatar

if you cant figure out how to unbolt it you shouldn't be trying to replace it

User Avatar

You have to take the steering wheel apart and go through there.

User Avatar

Remove the wiring harness from the back of your 1998 Chevy Lumina heater motor. Remove the heater motor retaining bolts. Remove the fan from the front of the heater motor. Reverse the process to install the new heater.

User Avatar

There is no distributor cap, only a ciol pack that the plug wires go to


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.