There is a tensioner that is easily moved with a 1/2" socket or breaker bar. Release the tension, and the belt will come right off. Route the new belt around the pulleys, push down on the tensioner again, and route the belt around the tensioner pulley. A very simple job that should take no more than 5 minutes to do.
You can find more Mark VIII repairs at www.markviii.org.
when trying to change alternator in my 1995 Lincoln continental but metal pipes seem to be in the way how do you get around them
Disconnect the battery and just remove the bolts holding the alternator, disconnect the wire connection and remove the alternator.
How do you change the alternator on a 1996 ford F350 diesel
how do you chance a serpentine belt on a 1996 ford escort
Serpentine belt See "Related Questions" below for more about Windstar serpentine belts - routing & installation information.
how to change an alterntor on a 1996 g20
You lose the functions of your power steering pump, water pump and alternator.
Remove the alternator belt from your 1996 Ford Ranger alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
take to the dealer
Remove the wiring harness from the back of your 1996 Dodge Ram 1500 alternator. Remove the belt from the alternator. Remove the alternator retaining bolts. Reverse the process to install your new alternator.
I need a step-by-step how to change, remove and replace an alternator in an 1996 Nissan maxima
what engine size? 2.0 soc does not have serpentine belts,has 2 serpentine timng belts. need engine size to help more.
how do you install a serpentine belt on a 1996 corsica?
Loosen the serpentine belt by removing one bolt and loosening the other on the belt tensioner located in the top middle of the belt position. Remove the serpentine belt from the alternator. Next remove the 3 bolts holding in the alternator and unplug the wiring harness attached. The alternator should now be able to come free with a little coaxing depending on its condition. Repeat in backwards order when installing a new alternator.
Remove battery wires, then slacken serpentine belt, remove wires from back of alternator, then frame mounting bolts. Re fit in reverse order. Not a difficult job.
by being clever
do you have the schematics of serpentine belt for 1996 Eldorado touring coupe
i paid 218 including alternator and labr. 159 for alternator and 45$ labor+ tax.
how to replace alternator on Toyota 4 runner 1996
loosen the one or two bolts holding the alternator in place, i believe 14mm, then loosen the 12mm on the adjuster (side) and "screw" the 12mm bolt down to lower the alternator down enough and replace the belt. This is almost the same for every Toyota engine which doesnt use an automatic belt tensioner (serpentine) on the alternator.
I think it has a serpentine belt,at least mine does You can put a 15mm wrench on the tensioner and pull it toward you, the belt will slide right off.
Most serpentine belts can be changed on the side of the road. It is usually an extremely simple procedure.
There isn't any fuse then is linked to the alternator on a 1996 Mercury cougar. The alternator has an internal regulator, but does not have a fuse.
Go here for your answer: http://www.cardomain.com/memberpage/338233/4
You will need to remove the serpentine belt from around all your components (ac, alternator, power steering pump, pulley, crankshaft). Then there are two 14mm bolts holding the alternator onto the assembly shaft. The manual suggests you remove the power steering pump first and then the alternator, so that you have more room. But you can also do it without. I would really suggest buying a manual before doing this. It is a simple procedure that will take a shade tree mechanic about 2.5 hours to complete.