look at the pulleys and you will see that one toward the firewall has what looks like a bolt to unscrew. Put a long wrench on it and turn( can't remember which direction ) . It will pivit on a cam and the belt will loosen. To put on the new belt just repeat. Make sure you make a diagram showing the way the belt goes on the pulley if you have no diagram.
AnswerObserve the routing of the existing belt then pry back on the tensioner ( It is spring loaded) to get the slack you need and remove the old belt. Feed the new belt around the pulleys then pry back again to slip the new belt on.Haines manual or on the inernet look up Autozone.com
code 41 -1993 Plymouth voyager - Alternator Circuit
A Plymouth Voyager does not have a maf sensor.
A 1993 Plymouth Voyager does not have a cabin filter.
20 gallons.
a voyager doesn't use an inertia switch
You can find a vacuum line diagram for a 1993 Plymouth Voyager in the owner's manual. You can also find it at various auto stores.
The towing capacity for the 1993 Plymouth Voyager is about 2000 pounds. This varies somewhat depending on the model purchased.
It is in the fuel tank.
20 gallons..
1993-1995 with the same engine, A Dodge Caravan from the same years will also fit.
It will take you about 3 hours to change a water pump on a 1993 Plymouth Voyager 3.0L. If you are unfamiliar with this water pump it will take a lot longer than three hours. The water pump is inside the passenger side of the engine, driven by the timing belt.