Chrysler Concorde

How do you change the spark plugs in a 1998 Chrysler Concorde 3.2 liter?

474849

Top Answer
User Avatar
Wiki User
Answered
2010-01-23 13:00:34
2010-01-23 13:00:34

remove the coil packs on top the engine with a small tork bit then change plugs

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The Concorde could misfire for several reasons. Start by checking for proper fire to the spark plugs. Then check engine compression to see if a cylinder compression is down.

Looking at the top of the engine. Look between the runners of the intake manifold and you will see six square black boxes all held on by two star head screws. Remove the screws and pull up the coil boxes, under these are your plugs. Use a deep socket to change the plugs.

If it is a 3.0 liter V6 EFI. Then it will be .044

The spark plugs are under the plug wires in the middle of the valve cover.

I access them from underneath, other people remove the wiper cowl and intake plenum.

Change oil every 3000 miles. At 100,000, change the timing belt, water pump, coolant, and spark plugs. Replace the air filter as needed.

You have to remove the intake plenum to access.

Easy job, they are located under the coil's. Disconnect the coil primary wire connector then using a torx bit remove the two screws holding the coil to the valve cover then lift the coil from the engine and remove the spark plug.There are no spark plugs on this engine.

The Chrysler 2.4 liter engines make you remove the top plastic vanity plate and the 4 runner intake atop the engine. Each of these should be just a few bolts that are easy to access from the top. Once you get these off you should see the plugs and short wires to coil. Search web on PT Cruisers and you will find more info.

you must remove the plenum on top of the motor to excess the spark plugs it is not hard but time consuming to say the least

Where and how do you find the spark plugs for a 1997 ford expedition?

undo the console on top of the spark plugs and they are 2 each 2 plugs they are 16 spark plugs in total

first you need to state what liter the engine is.

My Chrysler 300 SRT8 with a 5.7 Hemi has 16 spark plugs

http://e30world.com/Maintenance/BMW-E30-Sparkplug-Change

Replace plugs and filters, change fluids, replace serpentine belt. Plugs are replaced by removing fuel rails, removing coil packs over plugs, then changing plugs.

How to Change Spark Plugs on 4.6 & 5.4 Liter Check related link below

There are freeze plugs on the left, right, and rear.

Spark plugs are easy to change. One disconnects the batter and spark plug cables, and removes the old spark plugs. Next a person puts in the new spark plugs, then reconnects spark plug cables and the battery.

you have to take off the six coils! which are located on the center of the engine between the loops of the intake... and then just remove the spark plugs and replace with new one..

You will need to remove the spark plug wires on your Chevrolet 3.1 liter engine. Remove the spark plugs with a 5/8 deep well socket. Turn the socket to the left. The spark plugs will come out. Reverse the process to install the new spark plugs.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.