To change spark plugs on a 5.9 2002 Dodge Ram 1500, locate the old spark plugs. These are located at the end of the 8 wires inside the vehicle's bonnet. Remove the old spark plugs and replace with new.
Spark plugs and wires
how do i change the spark plugs on a Chevy silverado 1500
2008 and before has 8 plugs. 2009 and up has 16 spark plugs.
If it is a Hemi - it has 16 Spark Plugs if it is a regular 8 cylinder it has 8 Spark Plugs
They are under the 6 ignition coils. There is a coil for each spark plug. You have to remove the coils, and then remove the plugs.
The 5.9L V8 has 8 spark plugs.The 5.9L V8 has 8 spark plugs.
No. All 16 spark plugs on a 5.7L Hemi are the same.
The plugs are located under the coils on top of the valve covers. You will need to remove the coils to access the 16 spark plugs.
The spark plugs should be gapped to .040 inch.
Second generation Hemis have 16 spark plugs. Each cylinder has an ignition coil pack over one spark plug, and a regular plug wire connected to the other spark plug. Be extremely careful not to mix the wires up when you change plugs.
16, two per cylinder.
Champion # RC 12LC4 .040 inch gap
Disconnect the spark plug wires from the spark plug( best to do 1 at a time, so not to mix the wires). Using a 5/8 socket you can remove/install the spark plugs. Gap should be .035" and torque is 24ft-lbs.
rear spark plugs? there are 8 in a 4.7 6 in a 3.7 and 16 in a hemi what do you mean rear what model ram 1500 2500 3500?
ON the 4.7L there will be 4 on each side of the engine you have to take the little nut off then pull the plastic casing straight out and the spark plug is in that hole
per every cylinder is one spark plug......you have 8.
Spark plugs, air filter, wires ( if equipped ).Spark plugs, air filter, wires ( if equipped ).
The two plugs provide a more efficient and complete burn of the fuel.
It has 16 spark plugs. The upper plugs and lower plugs are different part numbers.
They are under the coils, which are located next to the injectors.
If you haven't already,Try replacing the plug wires and spark plugs and regap the plugs to factory spec.